Forum Replies Created
-
Posts
-
Re: Bookkeeping software.
for a sole trader, quickbooks is better than sage, I tried to change to Sage and found it all way over my head. It depends on your accountant though and what he is happy with, most accountants are brought up on SAGE so dislike quickbooks.
Quickbooks can print off invoices on blank paper (or email them of course) while sage require you buy pre printed invoices over which you details will be printed.
Support however is not so great on quickbooks unless you pay them for it and for a sole trader its not viable.Re: indsit dishwasher
remember these things dont start up for seemingly an age after shutting the door…….
hose clips are available from connect and are one use only.
0120100437 are the larger ones for the heater
012G1040028 the smaller for the circ pump.
the tools (clic) are available as are the clips on Ebay. and I am sure there was a recent thread on here.
dont forget to include the cost of these when quoting.Re: CDA dryer belt CI520
I guess the one marked EL is elasticated and once stretched is the same size as the other one?
has the machine got jockeys? assume its a white knight?Re: SMEG UK60MFX cooker
Just need to mention that there is also a UK60MFX1 model which does have a cooling fan fitted under the hob, just make sure you have the correct model number.
Re: SMEG UK60MFX cooker
As you have said you have a resistance of “10-50 ohms. ” then you have found your problem, fit the correct item, its not for you to change the original spec.
No, there is no cooling can on this one and the correct stat is retained by a screw on clip rather than being screwed to the back panel. Maybe whoever fitted the bosch item has not sited it correctly.Maybe also need to check oven temperature incase the thermostat is faulty.
Re: SMEG UK60MFX cooker
818730566 is he smeg part number and it is 140 degrees. Should be pretty much no resistance across the terminals.
Re: Stoves 444445537 front right halogen ring
pretty sure Halogen has gone out the window, always get a hi speed ceramic supplied these days as replacement and sometimes the customers dont like it!
Re: ASKO 9600
really ned the WM number Lawrence but would go for 80 080 03. As just stated. a Hotpoint normaly fits if you mess around with the restrictors.
Re: hotpoint hob 6343p
…and they can be a right pain when the leads dont reach! file under unnesesary modifications just to confuse us, along with changing the markings on energy regulators. 🙂
Re: hotpoint hob 6343p
AFAIK all ceramic rings have wiring mods. The old connectors for the hob hot light and the safety stat have changed positons. Need to be very careful when wiring these. Dont just wire by position of tag. you have a pair normally closed across the safety and a pair normally open across the hob hot light swtich. Best to identify these with a meter first. Usually you do get a bit of paper with the rings explaining this.
Re: ISE 10 1607 Door Lock Change
I would take a guess its not too much different from the old model, 2 screws under the front edge (may have to tip back machine to access) maybe a screw under the dispenser? Once the front panel is off, the cover around the door is probably spring clipped in place.
Let us know.
