Forum Replies Created
-
AuthorPosts
-
ELDAR59
ParticipantRe: Admiral/Whirlpool Fridge Freezer design fault ???
hello, it is very rare, almost unheard of, for this appliance to fault up again if it has been repaired properly to address the freezing in the fridge issue.
this repair would involve not just fitting a new damper, but also a low wattage heater to sit around the damper assembly.
this will solve the problem.
by all means approach maytag and see what they suggest, but it always amuses me when a consumer starts quoting ‘not fit for purpose’.
far better, in my experience, to tell them your problem and just ask them what can be done. i’m sure they’ll help you.cheers.
ELDAR59
ParticipantRe: Samsung RS21 water leak
hello, the broken water tank may just be another symptom of an overriding fault you have there.
you mention that you’ve defrosted the tank with a hair dryer. why did you have to defrost it in the first place?
normally, that tank should not freeze. it’s likely that you have a fault in the fridge evaporator area. maybe a thermal fuse, defrost sensor, defrost heater, evaporator cover, or any combination of those.
one of the symptoms of a frozen evaporator can be a split water tank and, in terms of probability, it’s very likely that the problem lies a little deeper than is first obvious.
i would call out an engineer in your area that has experience with these appliances.
cheers.
ELDAR59
ParticipantRe: FRIDGIDAIRE TALL FRZR FRF170FF
hi chris, f2 is evap sensor failure.
cheers.
May 7, 2010 at 7:30 pm in reply to: Service Technician looking for employment S. Yorks, N. Derb #319666ELDAR59
ParticipantRe: Service Technician looking for employment S. Yorks, N. D
hi mate, you could try tony at app, he’s always looking for engineers.
he’s notts based, is that too far from you?
cheers.
ELDAR59
ParticipantRe: Football season 09/10
totally agree jim.
i really can’t be doing with the irrational hatred of other teams. i’m very pleased that the north west is a hot bed of top flight soccer at the moment.
shame burnley could only stay the one season in there.well done the dale in league 2, just a pity they couldn’t win the league!
ELDAR59
ParticipantRe: Football season 09/10
small things pleasing small minds?
ELDAR59
ParticipantRe: maytag /admiral washing machine
thats it lawrence. done lots of these, never used the tool. just be careful loosening the screws, you’ll be fine.
ELDAR59
ParticipantRe: Prima LPR956
no probs.
have 3 of the rings failed?
configuration details are sent with the element i believe. not sure on the price of the elements though.
cheers.
ELDAR59
ParticipantRe: Prima LPR956
e4 means no commumnication between element and board. usually means that a new induction heating element is needed.
available from isdal.
new element will have to be configured.cheers.
ELDAR59
ParticipantRe: admiral side by side ff
hi mate, try code 05. that should work
cheers.
ELDAR59
ParticipantRe: Maytag Fridge Freezer dispenser
it’s going to be the front pcb mate.
cheers.
ELDAR59
ParticipantRe: Gorenje WA6111 a/w
chris, you could try putting a washer or two between the box and the cabinet, under the back screw.
this obviously has the effect of angling the back of the box down and does work.cheers.
ELDAR59
ParticipantRe: Admiral FF GC2224GEKB
kez, pm sent mate.
cheers.
January 30, 2010 at 12:11 pm in reply to: Fridge freezers v stand alone fridge & freezer for garag #310471ELDAR59
ParticipantRe: Fridge freezers v stand alone fridge & freezer for g
hello, if you had a seperate fridge and freezer, side by side, in your garage, you would find that the fridge would be cold enough inside already and so wouldn’t turn on via the thermostat, until the ambient temp was higher. so no need to turn it off for a few months.
your freezer would operate as normal, despite opinions to the contrary.
your only concern would be that, as both appliances would be technically operating outside their intended operating conditions, (ambient temp wise) then manufacturers could void your warranty.cheers.
ELDAR59
ParticipantRe: Admiral FF GC2224GEKB
this does sound like a tricky one mate!
the defrost termination stat is firmly fixed on the backflow pipe isn’t it?can you force the defrost via the board? do you know how to do it?
cheers.
-
AuthorPosts
