[electrofix]

will it run the spin programme till the end each time

if yes sounds like a faulty selector

Dave

[electrofix]

bit of a long shot

sent you info on test routine see if it will do that

Dave

[electrofix]

murv wrote:Connect 5045383476054 Door frame assy
Murv…

but showing as a special so its quicker to ring Stoves direct and find out if its obsolete

Dave

[electrofix]

check the contacts on the multi switch and the overheat stat at the rear

Dave

[electrofix]

well as far as i can see its obsolete

Connect are the only one i can see that list spares but all are listed as not available

you could try ringing stoves but apart from that it may be a scrapper

Dave

[electrofix]

well never seen an EBAC and you can only comment on what you have seen
in theory they sound ok but since you don’t come across them you tend to forget they exist

Dave

[electrofix]

get it hot and check dryer elements for earth faults

thats what i would try

Dave

[electrofix]

7017321

Dave

[electrofix]

gone are the days of buy our product its quality and its now buy our product its cheap

Dave

[electrofix]

well it needs a drum unit

you now have to make a decision

Dave

[electrofix]

neilbow wrote:Yes I had a Siemens machine that would only reset this way the standard turn to position 6 and turn one click to the right etc etc would not work

Regards

Neil

its like they have a full time employee paid to dream up odd reset proceedures lol

Dave

[electrofix]

neilbow wrote:This normally works for me

1. Turn off the machine (dial to 0)
2. Open the door
3. Turn control knob to position 1
4. Close the door
5. Turn off the machine
6. Turn the control knob to the six-o-clock program, which is spin
7. Press the option down button and keep it pressed (This is the button left of the display)
8. Turn the control knob one position left to seven-o-clock (empty/pump out program)
9. Release the option down button
10. Turn off the machine.

Regards Neil

thats like 2 reset procedures in one

but if it works foir you thats ok

Dave

[electrofix]

try this

from off press and hold start turn knob ONE “not two” clicks left after about 10 seconds an odd display shows, turn off all now seems ok.

Dave

[electrofix]

even if the machine is not chinese a lot of the components will be so there is not much in it

Dave

[electrofix]

there will be 2 wires to disconnect ( solenoid or activator and rinse aid level) the solenoid is part of the unit

Dave

[Author]

Posts