Forum Replies Created
-
Posts
-
Re: Zanussi compact washer, bearing seal part number please
looking up the other 2 models in this range
914904029 /00 and /01
they both use the same front bearing and quote the seal as
5009 55 15-00 / 8
Dave
Re: AEG KB9810E-M Combi oven
you need to look at the blown track and see where the current flow is
post a picture of the blown side of the board
also post the Pnc number as there are over 30 ovens with the same model and i will see if i can find some tech info
Dave
Re: hotpoint WDL5490
changed dryer ntc last time had typical pump runs for 5 secs and stops syndrome.
think it washes ok its just the dryer side that seems to be weird
think it may be a board fault this time but you can never be certain with this pile of junk
anyone got ant tech info on them ?
Dave
Re: Maytag fridge too warm, lights not working but freezer f
the air not only has to blow into the fridge but out again. there will be a return tube
try a complete defrost, turn off , door open for 2 days
might not make you lights work but if its an ice blockage on the return tube it will clear it
Dave
Re: Washer
depends on the model
early one just turn off and it will open after 5 mins or so
later ones have a door lock overide in the filter flap. pull it down and hold with one hand and open door with the other
Dave
Re: Bosch WTS84500
to do it properly you have to strip off the left hand side but as a quick check there is a panel inside where the condenser goes about half way back. has 2 plastic latches and you can lift it out and check the sump with a torch and a small mirror
to get the left side off you have to strip lid and top first then remove control panel to get at all the screws
Dave
Re: Smeg SS55PTE3 fridge freezer water connector
i think servast list the part your after but they hide gen part numbers
https://www.servevastdirect.co.uk/produ … 449&page=1
Dave
Re: How many machines have been written off
lots i would think. depends on your level of knowledge. i am lucky as I have a good working knowledge of electronics although more info on progamming chips would be good if i can find time to do the research
Dave
Re: Bosch Dishwasher SMS65E18 GB/33 dead
hi Paul
as a matter of interest can you get the boards pre programmed if not I assume you needs all sorts of kit and access to the software
DaveRe: Bosch Dishwasher SMS65E18 GB/33 dead
sounds like a power supply issue on the board
assume if you turn off and on again it repeats
Dave
Re: Leaking inlet valve on dryer side of Miele WT 945 wash/d
https://shop.ukwhitegoods.co.uk/un7122- … fill-valve
this is a generic dual valve. some unscrew some are sealed. if it unscrews it should work
Dave
