electrofix

Forum Replies Created

Viewing 15 posts - 16,171 through 16,185 (of 19,550 total)
  • Author
    Posts
  • in reply to: New world DW60 stopped working #434355
    electrofix
    Moderator

    Re: New world DW60 stopped working

    either

    1 lock needs changing
    2 top hoop may adjust does on some dishwashers
    3 door is strained so wont close properly

    Dave

    in reply to: Belling Countrychef 924 #438947
    electrofix
    Moderator

    Re: Belling Countrychef 924

    you need to get the model number which on belling normally start 44444???

    then ask the site shop

    Dave

    in reply to: BEKO WMB81241LW – not spinning #438945
    electrofix
    Moderator

    Re: BEKO WMB81241LW – not spinning

    machine wont spin for various reasons

    1 out of balance load
    2 water not draining quick enough or bad foaming

    then check you brushes for length or jamming

    Dave

    in reply to: Bosch washing machine – won’t turn on #438935
    electrofix
    Moderator

    Re: Bosch washing machine – won’t turn on

    sounds like a panel problem

    its prob repairable sounds like it may be the panel power supply or need a new panel

    you could get someone with the knowledge to look or

    remove your panel and contact

    http://www.qer.biz/Lists.htm

    Dave

    in reply to: indesit iwc6125 motor not turning much #438906
    electrofix
    Moderator

    Re: indesit iwc6125 motor not turning much

    as long as the magnet is turning and the coil is ok then it cant fail to work so cant see why you cant see a reading

    Dave

    in reply to: indesit iwc6125 motor not turning much #438904
    electrofix
    Moderator

    Re: indesit iwc6125 motor not turning much

    its not the tacho coil otherwise you would not get a reading

    in the end of the armature is a magnet. this magnet spins inside the coil

    check the magnet

    Dave

    in reply to: Bosch WM fabric softener drawer fills with main fill #438909
    electrofix
    Moderator

    Re: Bosch WM fabric softener drawer fills with main fill

    the tubes in the lid of the Bosch soap box often get blocked with sludge
    you have to strip the machine to remove the soapbox lid and clean it out

    Dave

    in reply to: indesit iwc6125 motor not turning much #438901
    electrofix
    Moderator

    Re: indesit iwc6125 motor not turning much

    the voltage from the tacho is very low and its AC not DC

    best spin the motor when its on the ohms scale and see if it changes

    Dave

    in reply to: beko dwd4310w no heat #438894
    electrofix
    Moderator

    Re: beko dwd4310w no heat

    did you ask EMW if they had a full test for the board or did they just change the relays hoping that was it ?

    Dave

    in reply to: Bosch WAA2426kby #438893
    electrofix
    Moderator

    Re: Bosch 2426kby

    take it you have plugged in in another socket or checked the on it is in is working ok

    Dave

    in reply to: Lamona dishwasher #438777
    electrofix
    Moderator

    Re: Lamona dishwasher

    does not make sense as a fault code but have you checked the base of the dishwasher to make sure its not flooded with water

    Dave

    in reply to: Fishing #438846
    electrofix
    Moderator

    Re: Fishing

    can see where you coming from K. have always looked at this game as a bums on seats theory. if a customer comes into the shop even for something stupid its worth it because they will remember you. A few times I have done stupid repairs and when asked how much I have said put £2 in the next charity box you see.
    It all breeds good will

    Dave

    in reply to: Fishing #438843
    electrofix
    Moderator

    Re: Fishing

    This is one of those quandaries

    you want to sell the customer a reliable machine but you would make more profit if it was unreliable

    Dave

    in reply to: Hoover Logic 1200 A3786 #438251
    electrofix
    Moderator

    Re: Hoover Logic 1200 A3786

    think i am right without checking

    from rear left hand side under a cover is a motor board. top of the board is 2 connectors. pull one off, insulate it, remove belt for safety. turn on and see what happens. if all correct motor should not move

    Dave

    in reply to: Ikea/Electrolux Renlig DWT 160 3 beeps on starting. #438830
    electrofix
    Moderator

    Re: Ikea/Electrolux Renlig DWT 160 3 beeps on starting.

    it sounds like the base is flooded

    as far as i know the aqua lock hoses stop after a predetermined amount of water has flowed in one fill. so if unit does not switch off water it will stop

    Dave

Viewing 15 posts - 16,171 through 16,185 (of 19,550 total)