[electrofix]

Re: How to remove front cover off Bosch Logixx WTS86516 Tumb

if its the same at the one I did today. remove the latch cover. its clipped on from the rear, easy to unclip with the left side off. then there is a screw underneath it holding the lock

Dave

[electrofix]

Re: Beko d/w module

that’s the old part number for same board new number 1899450440

part fully interchangeable

Dave

[electrofix]

Re: beko bwi643 dishwasher

think you need to check supply. on some programmes about 5 minutes is when the heater kick in and any bad socket will give up at that point

Dave

[electrofix]

Re: neff microwave anyone recognise it?

did a quick search and there is a similar door config with models starting H7871

Dave

[electrofix]

Re: Oven grill trips rcd when switching off?!

will most likely still be an earth fault prob on the neutral side but when its switched off the switch cuts the neutral first making it live and blowing the trip

Dave

[electrofix]

Re: Bosch Exxcel 1000 – error code 8

please post the machines Enr number so we know which machine your talking about

Dave

[electrofix]

Re: Solar plus model 48337 noisy

chances are the fan is at the back.

turn off the power and remove the back panel and see if you can access it

Dave

[electrofix]

Re: Microwave ovens and digital kitchen scales

is there any damage to the door at all ?

Dave

[electrofix]

Re: Neff washing machine – door open button not working

its connected to the on off switch bank

if you look at the picture the cable end goes into the white bit while the outer goes down the tube

Thanks to Qualtex for the picture

if you need a breakdown of the appliance go here
http://www.neff.co.uk/store/spare-parts

Dave

[electrofix]

Re: Neff s4457n0gb low water level on rinse

is the left hand side clear of gung

also I would check the valves on the left side think unit uses these side tanks as part of the fill so if they jam well maybe

Dave

[electrofix]

Re: Ariston A1400WD not emptying on wash cycle

to answer your question

the boards prob will be the same but the software is not. you cant even swop boards between the same models these days without checking first

the pump prob may be a fluke. these pumps have a problem with stalling as they get older. fill machine. then cancel programme, then set it to drain. then as soon as the pump starts pause the programme. wait 5 secs then start again. repeat and see if it stalls

Dave

[electrofix]

Re: Fagor induction hob

induction hobs use electronic panel to produce the power for the pan so there is nothing inside you can look at
there is one long shot
a lot of hobs use link plates in the terminal block where the mains wire connects. if these are not checked for tightness then you often find half a hob goes off

I have added a picture for clarity, you can see the brass links, turn off at the mains, remove term cover, look for burning/ melting and check all screws for tightness

[electrofix]

Re: Belling kensington 110e

2 leads on the left of the picture need to be joined together (by your index finger )

Dave

[electrofix]

Re: Belling kensington 110e

post a clear photo of the back of the clock and will see what I can suggest

Dave

[electrofix]

Re: Filling problem on Hotpoint Aquarius dishwasher

then it has to be some sort of blockage
as water enters the chamber it has to exit at the same speed

if you cant see a blockage try lowering the flow rate from the tap

Dave

[Author]

Posts