Forum Replies Created
-
Posts
-
Re: Beko DSC 64W cond dryer no heat
if you want to be certain link in a hotpoint heater ntc as a test. works a treat
Dave
Re: Bosch Exxcel 7 Door WAQ28461GB/12
I assume its bonded in some way. that’s a very expensive door and does not breed customer loyalty with prices like that
Dave
Re: Bosch Exxcel 7 Door WAQ28461GB/12
from what I can see its only available as a complete door at a very silly price £112
go here http://www.bosch-home.co.uk/store/spareparts/search
type in your Enr and you will see
Dave
suggest you glue it and look on Ebay
Re: Cannon Camberley 10101G Lid Springs
well I can find a breakdown but one site list the following
C00237777 lid spring right
C00237774 lid spring left
from my supplier they seem to be special order so cant say if they have been discontinued
email site shop and see if they can help
Dave
Re: Hotpoint Ultima Washer/Dryer WD865
its nothing you can do I am afraid
panel would either have to be replaced or repaired by an expert
Dave
Re: Miele Cooker Hood
according to the owners manual you press the switches to reset filter timers
no mention of fault codes unit might not have any
Dave
Re: Beko DSC 64W cond dryer no heat
heater thermistor 19.500 ohm @ 25°C
door thermistor 12.000 ohm @ 25°C
to be honest it normally the heater thermistor that causes this
complete heater only gen part no 2970101500
https://shop.ukwhitegoods.co.uk/2970101 … ment-11414Dave
Re: new format aeg condensor driers
if you had a prod number could look up tech to see if any problems listed
Dave
Re: Whirlpool LXR9245EQ0 Agitator replacement
go here
http://www.maytag.com/manuals/
put in your model and you will find a part breakdown
top of the paddle is held on by the central bolt so it sound like something has snapped
Dave
Re: Bosch sgs45e02gb/45 pumping continuously-not a leak
have you checked the microswitch in float chamber as this put a live direct to the pump
Dave
Re: Beko WMB 61631S Power issue
with all power loss situation you have to check everything. you have to get a live and a neutral to the board for it to work. you said you had power everywhere but have you got a neutral
Dave
Re: Old creda 48301 fan motor replacement ?
because there is a toc in the motor that custs out the element if motor overheats
so you have live in
neutral in and out to the elementDave
Re: Old creda 48301 fan motor replacement ?
the mounting of this fan means most motors wont fit as the shaft is long
most common motors these days are short shaft and the motor is bolted to the back of the oven. if you did fit one of these you would have a problem because the hole the fan shaft comes through is quite large to allow for movement so you would need to make a plate to reduce the size of this hole.
all in all I can understand your trying to help out a customer, we all do this every day but there may be a lot of work to modify this
Dave
