Forum Replies Created
-
Posts
-
Re: whirlpool adp 2304
if there is no sequence it will be fault 1
1 ntc
2 broken wire in door to ntc ( had one yesterday)
3 programmer faultDave
Re: Old creda 48301 fan motor replacement ?
did you know electrue have the correct motor in stock
Dave
Re: SIEMENS SN26M253GB/55 WIRING ISSUE
taking an educated guess at this one
this motor is a 3 phase motor. from my experience working on normal 3 phase machines if you cross the wires on a 3 phase motor it turns in the opposite direction
so if you cannot get the information you need and want to take a chance. run machine and see if motor is turning the correct way. if no you can swop any 2 wires and it will reverse
am making a few assumptions here and cannot be certain it will be correct but if it works the same as normal 3 phase it will
Dave
Re: Siemens HB75RB550B/05 oven trips RCD
if it were me I would disconnect all elements, fans and the lamp and see what happens then
Dave
Re: Siemens HB75RB550B/05 oven trips RCD
by the look of it small pcb is a power supply to the unit. cant see the earth cable on this causing the problem
also the trip will not go unless you get over 30ma to earth so a couple of megs to earth is okhave you tried a long shot and connected the oven to another socket?
Dave
Re: HOOVER DXC CB3/1
are you sure this model is correct as normally if it is it comes up on google
post the commercial code as well
Dave
Re: C17MR02N0B touch screen intermittently not working
ring and ask and explain it
you could even offer to send the video to them
Dave
Re: Candy washing machine spinning problem
it is impossible for the motor to run and the drum not to turn. if it did you would burn out the belt
so I think you can hear the pump motor but the main motor does not startfirst thing to look at in this situation is motor brushes
Dave
Re: Miele T260 electronics fault
I did not get any feedback to my reply so no resolution of the fault was arrived at
Dave
Re: symbols meanings please
all whirlpool models contain letters and numbers there should also be a 12 digit number to help identify model
look around the door and try to find this labelDave
Re: Oven went pop…
you need to source and replace the thermostat
the stat consists of the control behind the knob and a long tube leading to a sensor in the oven
DaveRe: AEG 5211V removing door glass
remove the oven door ( see owners manual for how)
then you will have to remove the screws that hold the outer glass in place
make sure you cant drop the glass when you do it so use a big table or better still the floor
Dave
