Forum Replies Created
-
Posts
-
Re: Whirlpool 7560/1 integrated dishwasher – Issues..Please
you could have gone too far too quick
to answer some of your questions
Q2 it an overflow pipe its meant to be open to let water leak into base
Q3 pincers is the tool you need but you have to bend the zig zag peice on the clip to open it a bit to put it back and crimp to seal
i said you went too far. when the unit started was there power to the main pump. if yes its the pump if no its broken wires or prog problem possibly. i say possibly cause there is always the odd fault that does not give the right fault code
Dave
Re: Problem Miele Professional WS5425 MC 13
this is getting to be an old machine but a good one
i would check the thermistor and look for broken wires in the loom as it leaves the drum. the flashing light is a fault code and maybe another member with access will help with that
spares are only available from miele and are expensive. you could look on ebay and see if anyone is selling second hand sparesDave
Re: Hotpoint DWF34
from what i can see on these boards the problem lies with the current flow which seems to flow through the plate through on the heater relay leg. before bosch recalled them i was fitting new relays but also drilling the board to solder 30a fuse wire from one side to the other to carry the current
had a few occasion where board had gone bang and blown chips but also ahd a lot that worked no probs
never had a failure after the modDave
Re: New world cke13001wh rhs oven thermostat
ot115 might as well says it has a 6mm spindle what size is the original ?
Dave
Re: New world cke13001wh rhs oven thermostat
from what i can see of the part look at qualtex part no OT42
cant say it will fit but if it does its cheap enough
check the capilliary is long enough
dave
sorry
got it wrong meant cs42Dave
Re: zwg6141p
dont this board but sound like it might be power supply chip on board. may also be scrap but the chips are cheap if you can solder
look in the simple pcb repair tip at top of this forum
Dave
Re: bosch smv40c00 no heat on wash…
as with all heater will still have a relay on the pcb
haave you looked for bad jointsDave
Re: Hotpoint DWF34
this was part of a recall for this very problem. had one done about 18 months ago by hotpoint. came out and replaced timer FOC
Dave
Re: Hotpoint DWF34
whats wrong with it QER list itv as one of the modules they may be able to repair
dave
Re: hotpoint ew74g top oven and top grill tripping rcd
no not really most of them are fairly simple
Dave
Re: hotpoint ew74g top oven and top grill tripping rcd
most likely the element
but can never say for certain without testing it
Dave
Re: Neff W/D, on dry,no water in
have you tried wet clothes in it
some machine do not turn on the valve until it detects wet washing
Dave
Re: Neff dishwasher door won’t lock
i assume this is one of the later locks which are not as strong as earlier models
i have had similar problems with this unit
try removing lower basket and see if it closes better. had a customer that had put a plastic peice at the back of the basket that was putting pressure on the door
other problem i have had is levelling. if unit is not square in the unit or legs are lowered so much it puts pressure on the roof it causes door problems. try lowering the dishwasher legs and see if door gets better
Dave
