[electrofix]

Re: Whirlpool/Ikea FXTP6 oven trips power off

most likely an element failing

Dave

[electrofix]

Re: Dishwasher Diplomat ADP8342 broken? Serial no FA53H0554

a lot of diplomat dishwasher where whirlpool but this one seems to be made by Haier
its a load of chinese junk sounds like you main pcb has failed. you could take it out and look for bad solder joints you may get lucky

panel seems to retail approx £100 so i woulds save up and buy a Bosch

Dave

[electrofix]

Re: Bosch SL1501B dishwasher Salt light always on

and the manual states

Programme data
The programme data (duration, energy
and water consumption) can be found in
the summary of instructions and refers to
standard conditions. Greater deviations
may be caused by:
different quantities of utensils
inlet temperature of the water
water pressure
ambient temperature
mains voltage tolerances
and appliance-specific tolerances
(e.g. temperature, water flow rate, etc.)

ie its cold so water is colder (winter) so you have to heat it longer on both wash and rinse to get to temp.
water pressure may be low or tap turned down or water valve letting in a bit slower than new.
if there are more item in the dishwasher all these have to get to temp as well

all there variances can add to the prog. if the eill valve is slow than it may not be long till you have to change it as unit times out if it takes too long to fill

Dave

[electrofix]

Re: smeg suk91mbl5 twin fan oven right fan not working

have seen one a long tome ago

but loooked up cooker part list and there is a relay board

part number 811650197 (do a google image search ) this board allows thermostat to control both elements without overlosding

check board for bad solder joints

Dave

[electrofix]

Re: smeg suk91mbl5 twin fan oven right fan not working

is the fan turning ?

if no
poss faults clock, oven switch

if yes
poss faults oven switch, thermostat

Dave

[electrofix]

Re: Bosch SL1501B dishwasher Salt light always on

does the owners manual state a time ?

tried to look it up but i need full Enr to find a GB manual

Dave

[electrofix]

Re: Bosch SL1501B dishwasher Salt light always on

is the dishwasher plumbed into cold water or hot

the most common cause of long programmes is heater failure. if yours is plumbed into hot you may think its heating when its not

Dave

[electrofix]

Re: Bosch SL1501B dishwasher Salt light always on

the salt light will not go out unless you add salt. as you are using 3 in 1 tabs you may not need salt so ignor it. also you should not be using rinse aid as the tabs contain it

is the dishwasher getting hot?

Dave

[electrofix]

Re: SIMPLE PCB REPAIR TIPS

25 watt iron is enough but you have to scrape off the varnish to be able to melt the solder

Dave

[electrofix]

Re: ISE T25WC Dryer Rear Fan

contact site shop they should be able to sort it

Dave

[electrofix]

Re: Bosch Classixx dishwasher water will not drain

did you check properly i have had glass peices that only catch if the pump is running and they are hard to see

if that is clear you are looking for blockages. check where the hose terminates at the sink. would also not be the first time i have had a fat blockage in a hose

Dave

[electrofix]

Re: JLDWS1204 – new soap dispenser causes RCD trip

there does not seem to any tech info on this
but
it does list it as a kit so did you fit everyting ?

also why did you not dispense with rinse aid and just use 5 in one tablet ?
if you are using all in one tablets you must not use rinse aid as you are double dosing and it can cause excessive foam

Dave

[electrofix]

Re: HDW1011WG (857008415101) has stopped heating the cold wa

are you certain dont know with this machine but if the door is double glazed its hard to tell and since rinses are cold you cant tell at the end
try a very hot wash to be certain

dont know with this machine but a lot of machine skip heater cycle without error code if not heat is detected. so its worth checking heater. also some whirlpool machine wont atart if heater is broken

still the first thing i would check once you are certain its not heating

Dave

[electrofix]

Re: Bosch Classixx dishwasher water will not drain

go to

http://www.bosch-home.co.uk/store/spareparts/search

put your Enr in

selsct parts diagrams

the drain pump can be seen on diagram 4 labelled 0424

to clear pump go to diagram 5 the cover labelled 0522 is accessed through the door. remove filter, remove screw holding filter. dry out with sponges and kitchen roll. look for obstrution and remove. i find a peice of wire coathanger with a small hook on the end is a great help

Dave

[electrofix]

Re: Dishwasher not heating

most likely is bad solder joints on board

cut out is on top of heater box you can check it with a meter as wire goes to stat then heater

dave

[Author]

Posts