Forum Replies Created
-
Posts
-
Re: Fan motor part no
looking at the normende site if its under 3 its still under warranty
http://www.nordmende.ie/warranty-terms
Dave
Re: adp8242
you can send it to me no probs let me know and i will pm you my details
its one component on the board that provides the power have done lots of them
Dave
Re: adp8242
then i know exactly what it is
its the power supply on the board easy fix if you can solder a new component into the board
i am sure one of the engineers on this site can sort it for you or i can if you are close to me or send me the board
what it does mean is your second hand board is faulty
Dave
Re: adp8242
if you listen carefully does this happen
set prog and start dishwasher
pump runs
machine fills
machine washes for a while
machine goes “beep beep” ( this can be very faint)
machine goes quiet for a few secs and then starts up againDave
Re: adp8242
when you say churns away do you mean full of water in washing mode
if so does it heat
where did the new timer come from was it new or used ?
Dave
Re: Washer only spinning at slow speed
to be honest they are known for being complete junk. if he has had it five years then that’s really good most don’t see the guarantee out
pay a bit more and get a bosch machine bit more reliable and you can get parts if you need them unlike the bush
Dave
Re: Zanussi oven # 944171283
the front and the oven cavity are separate parts
its not easy but you have to loosen the front to get a gap to install it
Dave
Re: Indesit IDC75 Belt trouble
if the belt is rubbing there its either wrongly installed or the drum has dropped
is the back bearing ok ?
Dave
Re: Miele W5748 washing machine cuts out
had a similar problem with another miele. machine would start and after a short time display would go blank and machine would stop. traced fault to a 5v regulator chip on the pcb
see simple pcb repair tips I documented it there
different board but similar faultDave
Re: Miele W828 rinse light flashing.
are you reading the motor drom the pcb arm , field and tacho ?
Dave
Re: SMEG DWI612C
the float is linked to the pump but only to pump out the wash water to stop floods
Dave
Re: Beko DW450 Not heating (but heater works)
have you looked at the programmer board for bad solder joint ?
Dave
plug out first !
Re: Diplomat ADP 8502 problem
its got to be a power supply problem on the programmer from what you are describing. its like the batteries going on your remote control
machine starts, there is not enough power to supply needs so programmer computer crashes, all light go off. prog reboots as power returns and process repeats
there is enough power to programme the unit but as soon as you start a prog its too much
some professionals can fix the board and there is some firms out there that will do it otherwise its a new boardDave
Re: Miele T260 electronics fault
i cant see that moving the machine around would cause this so you are looking at a paossible pcb failure.
dont know on this machine but when you use it normally does the diplay go out when you open the door. only ask because my miele washer goes blank when door is open. poss door switch problem?Dave
