[electrofix]

Re: Bosch/Siemans maglock style Dishwasher Door Locks

i had one that was doing that through bad fitting

sounds like when it get hot its enough to expand something and cause the door to pop open

make sure its square if one leg is too high it twists door
make sure the hinges have not been strained

Dave

[electrofix]

Re: lamona 8300 dishwasher boiling when finished

if its the pcb in door

pt no 1741411400

[electrofix]

Re: AEG dishwasher 35085VI intermittent stopping mid-cycle

sent you a PM

Dave

[electrofix]

Re: Amica w/m awct10l module part no

since this site is the main u/g amica spares supplier ask the shop

had a few of these where the fault was the large blue cap think its 2.2uF from memory

Dave

[electrofix]

Re: AEG dishwasher 35085VI intermittent stopping mid-cycle

can get the service man but need more info

full model is F35085VI
there are 5 of them with different pnc no first made jun 06 to the last one may 09
pnc numbers end 0300, 0301, 0302, 2200 and 2201

Dave

[electrofix]

Re: beko GNEV321APX -HUMIDITY LIGHT ON

no probs m8

its the silly faults that give you the most headaches lol

Dave

[electrofix]

Re: Assistance please

you have the same problem we in the trade meet every day

the model number on hotpoint machines is not enought to get the right part. have looked up your model and got 3 different heaters. (even on the ebay page you bought from mentions another heater)

inside the door is a label. on that label is 3 numbers
1 model CTD40G
2 commercial code
3 serial number

you need all 3 to be certain its the right part

if you post those numbers i am sure someone hers with access to that info may give you the correct part number

Dave

[electrofix]

Re: Fridgemaster bottle shelf

i would ring qualtex

they have a few things coming up for you model

Dave

[electrofix]

Re: Smeg Integrated Washer Dryer

is cutomer leaving the dryer to run its progamme. ie running the cold 10 mins at the end

Dave

[electrofix]

Re: beko GNEV321APX -HUMIDITY LIGHT ON

i would ring beko as the customer and ask them

dave

ps take it you have the service info

[electrofix]

Re: bosch 494747 hilight hotplate

had these sort of problems on other hobs. no doubt a wiring change

if you post pitures of each plate then someone may be able to help

Dave

[electrofix]

Re: beko GNEV321APX -HUMIDITY LIGHT ON

that must be the only indicator they dont mention in the service manual

have you looked in user book ?

Dave

[electrofix]

Re: hotpoint dryer tdc 32

when the stats blow then the clean filter light comes on

if the stats are blowing then things are getting too hot its either

1 faulty element look for broken elements that can touch each other
2 faulty air flow check fan, filter, condensor

Dave

[electrofix]

Re: Zanussi ZJD-12191 Error E36 – flashing start/stop

electroulux list this fault as follows

E36 Sensing circuit on anti-boiling pressure switch 1
defective Main board defective.

does not sound too promising

Dave

[electrofix]

Re: Beko WM5120W Washing machine-Spin cuts in

does it work normally on the wash programme

ie motor turns slowly

Dave

[Author]

Posts