[electrofix]

Re: Hoover condenser dryer HDC6

i await the next installment with anticipation

ask her if she can do nuclear fusion as well ? lol

Dave

[electrofix]

Re: Hobart commercial dishwasher repair PR4 Tarleton

if its basically running got to be down to heat detergent or blocked jets

Dave

[electrofix]

Re: Hoover condenser dryer HDC6

well its got to go somewhere and if its not leaking it must be getting out as steam into the room

Dave

[electrofix]

Re: aegL12510 vi flashes E30

according to manual if you turn off power fault resets

if you need the manual send me an email

Dave

[electrofix]

Re: Fault Code Guide

thanks was trying to do this to put on a netbook to carry with me saved me a lot of work

Dave

[electrofix]

Re: Hobart commercial dishwasher repair PR4 Tarleton

do you know what the problem is ?

Dave

[electrofix]

Re: Bendix AW1002W fault code

have not got manual for 1002 model but have for 1001

assuming 4 flashes end of cycle light
3 flashes start pause light

fault code 43 = from lux manual

Example: Alarm E43 (problems with the door interlock triac) will display the following:
• the sequence of four flashes of the END OF CYCLE LED indicates the first number (E43);
• the sequence of three flashes of the START/PAUSE LED indicates the second number (E43)

hope this helps

Dave

[electrofix]

Re: aeg w/m will not start

😆

machine was in unheated kitchen
result cooking steam and cold motor = condensation

Dave

[electrofix]

Re: aeg w/m will not start

had zanussi the other day same fault

condensation on motor

Dave

[electrofix]

Re: wet motor

hair dryer did one the other day

Zannissi auto fault 51 (i think) motor triac short wet motor gives same fault down to condensation on motor

Dave

[electrofix]

Re: hotpoint door boot wire

thanks

Dave

[electrofix]

Re: cookers dishwasher

thanks

Dave

[electrofix]

Re: whirlpool adg642

you need the commercial code and you should get from here

http://my.whirlpool.eu/app.cnt/whr/whr_ … ionsForUse

hope it help

Dave

[electrofix]

Re: Creda W220VW Diagram

if you look most connections will only go on 1 position

look at the pcb and the slots on the plugs

the only connection that different is the 2 single wires on the right of the timer the wire with the terminal cover goes on the right hand side

hope this helps

Dave

[electrofix]

Re: whirlpool AWD 10561 sticks on 1 minute to go !

bosch have this problem and its normally an earth fault on heater. not enough to blow an rcd but enough to mess with the electronics

hope this helps

Dave

[Author]

Posts