[electrofix]

Re: Zanussi ZWF 1430 E90 code

all the E90 codes relate to pcb errors e90 is shown on display and you can only see correct code by going into engineering or service mode

E91 & 92
Communication error between main PCBdisplay
board
(versions not compatible)

E94 Incorrect configuration of washing cycle

E95 eprom communication error

E97 prog selector and cycle config error

try the following
disconnect wire leading to display module from main pcb
turn on machine wait 5 secs and turn off again
reconnect wire and turn on

may not work but worth a try

Dave

[electrofix]

Re: Tricity Bendix SI530GR

look above in sticky

diamond h wiring ref

Dave

[electrofix]

Re: Tecnick DW2677/1 (whirlpool) wireing loom damaged.

should be 480140100687

listed as protect wiring but check on it have no breakdown but if you do a google search did find a site with a picture

wire
somtimes if the wire will move there is enough slack to pull wire up or down and joint it. if not find a new peice of suitable wire from a scrap appliance (not stripped flex) and joint top and bottom. also where there is 1 wire gone the rest will be going check for cracks in the insulation and repair if necessary. As an added precaution if possible move the harness about 1 inch higher or lower so it bends in a different place

hope this helps

Dave

[electrofix]

Re: Zanussi ZWF1437 time 155 and ERR

ZWF 1630

same fault
same cure
works a treat

thanks

Dave

[electrofix]

Re: bosch WFO2467 GB/17 fill and spin fault

@ martin

no have not megged it but will do and see what i get

thanks

Dave

[electrofix]

Re: bosch WFO2467 GB/17 fill and spin fault

any thoughts ?

[electrofix]

Re: Another beko wm6152w

checked for interest

you can get

tacho
tacho cover

but not magnet

brushes for this model are the same as hoover qualtex car75 so worth keeping in stock because it fits so many machines

Dave

[electrofix]

Re: Bosch WF02467 filling fault

got same fault on WFO2467GB/17

was there any resolution

Dave

[electrofix]

Re: WDL 540 Hotpoint washer dryer

if just 4 lights flashing

check in known error codes above ? F15

if all lights flashing check simple pcb repairs

Dave

[electrofix]

Re: Bosch wae28363gb/06

if you had searched ” boscsh reset ” clicked search all terms
you would have found

http://ukwhitegoods.co.uk/modules.php?n … 81b51f60b2

hope this helps

Dave

[electrofix]

Re: IZ16s counterweight

thats fun isnt it you would think Zann should take responsibility ofr this one will cost customer a packet to replace complete tub

Dave

[electrofix]

Re: Using Search facility

and i dont need glasses to see them GREAT !!!

Dave

[electrofix]

Re: Using Search facility

Maybe a large pop up that appears when you click new post

“USE THE B*****Y SEARCH BUTTON”

might help 😆

Dave

[electrofix]

Re: Zanussi zwd1681w.

done check you email

Dave

[electrofix]

Re: AEG Lavamat Turbo 16830

cannot look up your machine as i need the 9 digit production code but
A lot of the early AEG autos have a motorised soap draw

if you are geting a clunk clunk clunk sound when or before machine fills this is likely to have jammed

needs to be replaced as a complete soapdraw top

Dave

[Author]

Posts