[electrofix]

wires break internally as it goes through the wiring clip on the heater box. Had a few

Dave

[electrofix]

you could try descaler

Dave

[electrofix]

ok check your email

Dave

[electrofix]

does sound like a defrost problem

the ice is buiding up and blocking the ducts to the fridge

could be a blocked drain hole in the freezer or a failed defrost element

Dave

[electrofix]

did you check the cooling fan was operating ?

Dave

[electrofix]

every time you see his name your in for an essay
gave up reading his post to the end long ago as i get bored by the third line

he has answered post from years ago that were well closed with incessant ramblings as you said above

has obviously got nothing else to do because unless he can touch type it must take ages to write

Dave

[electrofix]

yes i get the 921 number

described as security thermostat

Dave

[electrofix]

have had situations where the freezer is set too far back so the cabinet door closes before the freezer door. this leave the freezer door slighlty open and frosts everthing up

Dave

[electrofix]

ok check motor brushes
does not normally happen on Bosch type machines but on some machines if brushes go machine wont run

also try disconnecting both heater wires and see if anything changes

Dave

[electrofix]

BrianT wrote:Could it be the water inlet valve? That’s what the Bosch site suggests for E3.

no its letting water in its just to quick for matrix

Dave

[electrofix]

select spin only without rinse and see what happens. give it 5 mins as drum does not turn at first

what am trying to do is find out if anthing works at all

at the moment its got all the makings of a board or door lock fault

Dave

[electrofix]

take that chamber apart. something is stoping the water getting out of it

the water is coming in faster then its getting out

or you could turn the tap down a bit and lower the flow rate and see how it goes

Dave

[electrofix]

does the door lock ?

Dave

[electrofix]

ok looking at the pic i would say the only difference is a cut out. you could get the other one and file or cut it out

you may have a slight gap as it looks different at the lower part of that side peice

cant be 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} as you can guess but pics look very close

Dave

[electrofix]

there is a float in the 0410 unit
start the cycle and watch the float
i bet the float is going up and down starting and stopping the water flow

if yes it has to be a blockage

Dave

[Author]

Posts