Forum Replies Created
-
Posts
-
dunston wrote:Thanks Dave.
Have you had a water inlet solenoid valve damage a PCB?no but there is always a possibility
if it did i would expect a shorted triac which i would expect it to start filling on switch on
Dave
there is a lot of black on the plug which i would not expect
whats the back of the board like ?
Dave
service manual wont show you circuit board components
if you want to post clear pics of the board we can have a look
if pics are over 2M you will have to host elsewhere and post a link
Dave
If you join the trade side and post there will see if we can move the thread
hoping Kai may have the answer on how to put it into test mode to clear the fault
Dave
have you looked at the flow meter as the tech mentions it
its in the side air break unit part no 766610243
Dave
the impellor jug is most likely, changed a few
the way it works is there is a magnet on the impellor and as it passes a reed switch it causes the contacts to close
you can use a multi meter on the buzz continuity setting and as it turns you will here the pulses
to repair you can either replace the whole unit or but a reed switch and solder it in
Dave
ow I know that injury
cushion floor an be a problem but wahing liquid or using screw drivers as rollers can help
I would check the board and look for blown caps
Dave
the new ones are a lot more efficient and with your compressor working overtime , and probably all the time its costing you money
Dave
