[helo_75]

you might be better changing the heater box complete

[helo_75]

your bearings are goosed

and its not really a diy job, quite physically demanding, and depending on the amount of wear, could be £80-£120 to put right properly

[helo_75]

same machine, different spin speed thats all

[helo_75]

when u turn the drum by hand, does it rumble?

if you open the door, and just try to lift the inner metal drum by the front edge, is there movement?

if there is, its a sign the bearings are going/gone

[helo_75]

is it oil?

theres a good chance the bearings are shot, to be honest

[helo_75]

8 mths ago

do people ever read dates anymore?

[helo_75]

it could be the fan!

has it had the modification done?

obvously the air isnt getting into the fridge… if the fan is running, there is an obstruction in the flow vent

[helo_75]

the capacitors probably faulty if it will go with a push

not the nicest of jobs, just takes time

[helo_75]

no, but itll probably need defrosting before you take it off

two screws at the front, and it should slide forward easily

if it doesnt, itll be full off ice, and needs defrosting

[helo_75]

we would have to advise you join up for trade access

this subject has been discussed to death in there

click the link above to join

[helo_75]

the motor tacho is faulty.. check the wires to the motor plug/pcb

ive had a few of these where the wires have broken in the motor plug, the wires are just to tight

[helo_75]

in a word, no

sorry to say that

[helo_75]

dual regulators turn both ways

if theyre all the same, then no

[helo_75]

since most bosch appliances are supplied with a 2yrs guarantee, it isnt really an issue is it?

you should be covered, theyre supposed to hold up to putting heavy, water filled pans on them

they should at very least send an engineer out to assess the problem

[helo_75]

theres a good chance the regulator is faulty on both of them… the inner ring only comes on on lower settings generally

i take it the rear one is just a single one?

[Author]

Posts