Forum Replies Created
-
AuthorPosts
-
helo_75
Participantdont be surprised if the pcb is fubar
need to count the flashes , then you’ll have a better idea, but it might be worth checking the heater
September 20, 2008 at 9:57 am in reply to: Beko WMA 510S – pulsing cold water supply on spin cycle?? #261885helo_75
Participantdoes that mean he wont be able to log in now? if his user name is different and he’s not changed it.. what happens now?
helo_75
Participantnon communication between boards
try cleaning the connections first, or it could be a faulty boardhelo_75
Participantthey do go, its not unusual
make sure the fan motor runs, theres water comin in, and the heatrs ok before you replace it
helo_75
Participantpeel the door seal back, ull see it… obviously check ts tight
theres one on the top too
other than that, yes it could well be the legs, look undernath and youll see them
helo_75
Participant3 & 4 if f03
that being an ntc fault
if you’re very lucky it could just be the ntc (in the heater), or even a broken wire…
sadly these machines are the usual indesit tat, and are renowened for their unreliable electronics…
be prepared to have a pcb and eprom fitted
helo_75
Participantlol
i think id be checking the weight on the front of the drum first………….
helo_75
Participantheater realy on pcb sticking
itll need a pcb and eprom, ant then you just gotta hope you dont get the dreaded f12 fault
helo_75
Participantactually no
get a zanussi one, http://www.comet.co.uk/shopcomet/produc … -ZDC47100W
is as good as any condenser dryer available at the momentstay away from hotpoint/indesit and your near where you need to be
helo_75
Participantyou got mail…
helo_75
Participantemail?
September 17, 2008 at 6:56 pm in reply to: Bosch KGN34X60 Fridge-food expriring before best before date #262797helo_75
Participantthere should have been 3 parts fitted on this appliance to cure your fault
the parts generally cure the fault
i cant go into specifics, you need to find out which parts have been fitted
has it been bosch that have attenfed your appliance, or a 3rd party?
helo_75
Participantf10 is not sensing pressure switch
usually switch or board or wiringhelo_75
ParticipantRe: Hotpoint TDC30P Thermo Wiring Help Please 🙂
makes no difference, its fine
helo_75
Participantcough……..
-
AuthorPosts
