Forum Replies Created
-
Posts
-
well, u could help us by tryin to explain whats wrong with it?
if they cant repair it within warranty, theyre legally bound to replace it!
Re: Hotpoint WD420 stuck mid wash
f05
pumps not responding – could well just be blocked.. unplug before checking!!
access throught the back, btw
id just check the pin that holds the pecker on the door hasnt slid out, it would stop the pecker activating the lock
e30 would point to an incongruency betyween the analogic pressure switch and the antiboil switch
of course it could be a chaffed pressure tube, thats common
in laymans terms, it isnt sensing the water level
id check both pressure hoses/pressure bottle
deffo plug out b4 inspecting
if its a water cooled pump, u’ll probably be able to change just the pump rear, by undoing the screws, that makes it a lot easier, as most manufacturers use the same base
hovers part number is
09200399
thats the one listed on hoovers tech site for all models after serial numbers after 449, the earlier one wont fit
hth
