Forum Replies Created
-
Posts
-
inside main oven door, under the bottom of the seal, right at the very bottom
you do need the right model, as thats just a name..
countless fsds for that im afraid
Re: indesit WIA111(uk) cannot reset program?
funkyboogy wrote:you can purchase a card reader/programmer from connect etc ..
it plugs into new module > then you insert smart card which is supposed to prog new module .. smart card is a one shot so if pcb doesnt prog for some reason … its another new smart card …
what a total rip……
think ive read somewhere that emw do configured pcb,s …
ally
unfortuntely, a smart card reader isnt enough to reprogram theseu need a low end adapter with it
however that pcb does still have an available eprom, it still doesnt come with one
emw is the best option, every time
just take the sump off from the bottom of the drum and clean out the filter, and all will be ok, its a common complaint on washer dryers im afraid
they always appear to be emptying fine, but, trust me, its not
well, ud normally look through the holes that are
left when the lifter isnt in place first!then u can try lookin through the heater hole, failing that, its a drum stripdown
its a worthy project to be honest
we say it a lot, but THEY DO NOT MAKE THEM LIKE THAT anymore
a fine example of brtish manufacturing at its best
good luck, let us know how u find it when it comes back
C00053573
is the one in the tank
oops it would appear that its the only one fitted on a wd12x …my mistake,
but then im just a useless comet engineer, what would i know?
the shaft is the same
if u just have the c00113038 kit in stock, it gives u everything you need for both
including the teardrop bearing
e3 is a heater fault on that too
theres a memo about the heater being down enough to make the board think its still full
