Forum Replies Created
-
AuthorPosts
-
helo_75
Participanttheres a good chance the capacitor is at fault
pig of a job tbh, long winded, dangerous and plenty hard work
helo_75
Participantmore like the tacho has detatched itself from the motor
tilt it back, have a look
helo_75
Participantc00258799
helo_75
Participantits over soaped and in suds lock
keep rinsing it till its clear, then use proper powder, and less of it
p45s suggestion is the best one
helo_75
Participantid still try a lock
but its probs pcb
helo_75
Participantfrom the manual
Demo Mode
If the machine is on Demo mode ‘D on’ will be displayed and the machine will NOT function.
To reset the machine for normal use:ยท
Turn the power off at the wall.
Push in and hold down the Start/Stop and the Start/Reset
buttons, while still holding down, turn the machine on at the
wall.
‘D off’ will be displayed and the machine will function
normally.March 30, 2010 at 12:03 am in reply to: Hotpoint FF92 PCB – WHAT DOES NEEDS CONFIGURATION MEAN? #316700helo_75
Participantyou have email
March 29, 2010 at 10:26 pm in reply to: Hotpoint FF92 PCB – WHAT DOES NEEDS CONFIGURATION MEAN? #316698helo_75
Participantin fact, inbox me with your email address!
March 29, 2010 at 10:25 pm in reply to: Hotpoint FF92 PCB – WHAT DOES NEEDS CONFIGURATION MEAN? #316697helo_75
Participantstrangely , it says programmed, requires conffiguration
later pcbs required and eprom dump as u call it… but im sure that wont need it
March 29, 2010 at 7:49 pm in reply to: Hotpoint FF92 PCB – WHAT DOES NEEDS CONFIGURATION MEAN? #316695helo_75
Participantim not sure thats the right pcb
does it look the same?correct part number is c00218671
and im pretty sure that model is too old to need reconfiguring
should be plug and play
helo_75
Participantjust time consuming, and fiddliy
top off
remove soap drawer, then bezel, by unclipping it
2 screws under kick plate, two on topseal and lock off
the front panel should lift off
you may well have to remove one of the weights
2 good size screwdrivers will help you ptrize the retaining band on
just take your time and be methodical
good luck !
helo_75
Participantyes its the capacitor
http://shop.ukwhitegoods.co.uk/Tumble+D … citor.html
is what u need
side panle off, situated next to motor
make sure u unplug it !!
helo_75
Participantdoor lock.. door spring.. faulty motor.. faulty pcb
take yer pic
to be fair its normally an overheating motor that does that
helo_75
Participantill give it 2 weeks…..
-
AuthorPosts
