Forum Replies Created
-
Posts
-
Martin wrote:
helo_75 wrote:
its just the usual cloak and dagger stuff from martin… write it in a book, lock it awayI love you too sweetie! Give me your email and I’ll make certain sure I don’t leave you out either. 😀
if only… dont need u martin.. i think i asked for advice ONCE on here
the day i need advice off you ,itsll be time to turn my toes uplove you too
xRe: Zanussi Guarantee ZWF 1207
nospin wrote:I’ve written off 4 Zanussi washers in the last 4 months. I’ve replaced everyone of them with ISE AW23’s. At least you can do a bearing change on them at a fraction of the cost. I can’t believe LUX are making this crap. They as far as i’m concerned are the worst machines money can buy. The worst cabinets, strange faults, sealed tubs with crap seals and bearings. What next? I reckon soon the drain pump, motor and control board will be sealed in so if anything goes it will goodbye :o(
youve never tried to fix a haier then, have you
hold the top left and top right buttons on the panel together for around 7 seconds… the display will go out, and the error code should show up….
because it needs to get to a set temperature before it will advance… since its a cold fill machine, it needs to heat the water up
just change it and all will be ok
im not typing it sll out again…
nah, the motors are just crap
ive fitted new motors and theyve burned out while ive been filling the job sheet it
looks like your heaters blown, and took out the pcb.. countless variations on that machine, it will get messy
id be cutting my losses and putting the funding towards a better quality machine
