Forum Replies Created
-
Posts
-
Re: Hotpint E6005 Hob
thats all i can think of, the board is mounted on springs to get a good contact with glass, either that or the glass may not have fully seated onto the board? hth
Re: Hotpint E6005 Hob
did you raise the glass back off again after to see if all the springs on the touch module were correctly in place?
Re: Zanussi FLE1216
dont suppose anyone got the qualtex part number, their website really it pants for searching, masterpart has the seal oos, may get them from shop, whats the delivery time like for shop items?
Re: Zanussi FLE1216
did used to do zanussi bearings but that was a few years ago, from what i remember its back of cabinet off, remove wiring/hoses then drum out & split, not too different from a WMA, but that was a while ago,
Re: Hotpoint FFS 70
yes, have seen it before, not alot that can be done though, if the temp is ok then best laft alone
Re: Hotpoint Aqualtis
basically the hotpoint machines will all be EVO2, as will indesit models that use a programme dial that does not ‘click’ round through the programmes, EVO1 machines were the older indesits where the dial spins in fault mode
Re: Time for a rethink.
would have thought that would send many on here to try to self fix, but quiet on the forums too, all very odd!
Re: indesit di 620 dishwasher error lights 2 and3
sounds like when you re-fitted the new board the button has not aligned with the switch on the board,
all you need to do is make sure the button on the board is being pressed in
