Forum Replies Created
-
Posts
-
Re: Indesit IWDE126
F13 fault just plug a thermistor it was the same one as the wash thermistor but they cannot stand the heat and fall apart, replaced by C00290251
Re: Starting up an Appliance repair business
Dennis if you still have your gas i can shove bit of work your way, i get loads of calls for Gas in this area but i dont know anybody who i can trust and that i’d be willing to recomend, drop me a line and i might be able to help a little, JJ
Re: HJA 8630 heater staying on when empty?
Its only £13 for the board why bother fitting a relay to the old one, think i’d splash the cash and try a new board.
Re: lpr600 d/washer
Could be the owi sensor they get gunged up, sometimes cleaning them works or a new may be required, JJ
Re: Hotpoint WDD960
Where did you get the board was it a new one? or a repaired one as i would still be looking at a duff board JJ
Re: Hotpoint WDL520P all option lights flashing
I would check the dryer thermistor and the dryer heater 1st these throw up all weird and wonderful faults, just fitted a dryer heater, fault was fills okay then stops, lights flashing and would do nothing else wash, drain or spin. JJ
Re: Hoover HOD6615 Dishwasher no heat
Cheers Dragan i went back and bypassed the pressure switch and it started heating so got one on order, JJ
Re: Does anyone use this loop tester info required
Yes thats the same one, the Indesit guys also use that one also its okay, the EZ is smaller and automaticly does the polarity check then does the loop test, the socket and see does the polarity check then you press a button for the loop test i prefferd it for ease of use and its size.
Re: Re pipe clips
I use these 5031687916532 and 5045174174251 from connect i know a bit pricy but i make enough of the job to cover the cost and i know it aint going to come back and bite me.
Re: Hotpoint WMA56
I always change seal and lubricate with some washing up liquid never get a call back for leaking.
Re: Does anyone use this loop tester info required
I used a Martindale EZ650 for years fitted in my toolbox and didnt take up a lot of room, i left it in somebodys house i now use the socket and see tester that i got from an ex subby from bg for free, for doing a job for him, i still prefer the EZ650.
