johnnyj

Forum Replies Created

Viewing 15 posts - 496 through 510 (of 1,251 total)
1 2 3 … 33 34 35 … 82 83 84
  • Author
    Posts
  • October 9, 2011 at 4:47 pm in reply to: Late Hotpoint motor brushes. #360442
    johnnyj
    Participant

    Re: Late Hotpoint motor brushes.

    The part n/o is C00114885.

    October 9, 2011 at 4:38 pm in reply to: Hotpoint Soap Box Saga #360779
    johnnyj
    Participant

    Re: Hotpoint Soap Box Saga

    if you reverse the old one it should fit? JJ

    October 9, 2011 at 2:49 pm in reply to: APL8224/1 #360555
    johnnyj
    Participant

    Re: APL8224/1

    Its okay turned out to be a broken wire on the door, cheers j

    October 8, 2011 at 5:01 pm in reply to: Ariston A1636 top light flashing #360868
    johnnyj
    Participant

    Re: Ariston A1636 top light flashing

    F08, could be press sw, or faulty module but i would check the element 1st, had lots giving this fault if the heater is down to earth, especialy if the sump was full of coins,

    October 2, 2011 at 8:04 pm in reply to: Going Ltd #360374
    johnnyj
    Participant

    Re: Going Ltd

    Cheers Jim my concern was all the hassle about changing all my accounts etc that has put me off in the past.jj

    September 28, 2011 at 5:56 am in reply to: BOSCH SGS45C08GB/09 #360099
    johnnyj
    Participant

    Re: BOSCH SGS45C08GB/09

    Cheers Martin

    September 24, 2011 at 6:22 am in reply to: Hotpoint BWD129 dry cycle always runs #359439
    johnnyj
    Participant

    Re: Hotpoint BWD129 dry cycle always runs

    Ive fitted a few front pcb causing this usualy does it intermitantly, not as expensive as the main pcb.

    September 17, 2011 at 7:30 am in reply to: HAUS washing machine WM1050W #359136
    johnnyj
    Participant

    Re: HAUS washing machine WM1050W

    Connect have them at £9.82 1st part on the page, JJ

    September 17, 2011 at 7:26 am in reply to: BEKO DRCS76B 7KG CONDENSER #359099
    johnnyj
    Participant

    Re: BEKO DRCS76B 7KG CONDENSER

    Hi Bob can you send me the tech info, i had one snapping belts, i removed the drum the last time and replaced the bearing pads as they looked like the drum might have been jamming on the duct on a large load, i’d like to be sure i know what is causing it cheersJJ

    September 8, 2011 at 6:23 pm in reply to: indesit DIF 04 , intermittent operation #358525
    johnnyj
    Participant

    Re: indesit DIF 04 , intermittent operation

    Got one of these to fit tomorrow, not a bad job?

    September 6, 2011 at 4:28 pm in reply to: Diplomat ADP8332 not heating #358373
    johnnyj
    Participant

    Re: Diplomat ADP8332 not heating

    Try the Pressure sw situated in the sump try putting some hot water in the sump and using an old tooth brush give the black grid of the pressure sw a good clean that sometimes works as they can get gunged up, if that doesnt work try a new sw cheers JJ

    September 3, 2011 at 7:27 am in reply to: WMA767S Bearings #358213
    johnnyj
    Participant

    Re: WMA767S Bearings

    Cheers jim

    August 30, 2011 at 1:48 pm in reply to: Whirlpool AWG338 #357957
    johnnyj
    Participant

    Re: Whirlpool AWG338

    cheers john

    July 29, 2011 at 5:19 pm in reply to: Indesit DIF04 Dishwasher (Two in a week with the same fault) #356415
    johnnyj
    Participant

    Re: Indesit DIF04 Dishwasher (Two in a week with the same fa

    Jims right had a few with the wiring stuck to the bitumen and breaking, hopefully its only one or two but i had one with almost all of them broken or just about to break had to get a harness for that one,

    July 24, 2011 at 8:03 am in reply to: FIDW42 Dishwasher #355876
    johnnyj
    Participant

    Re: FIDW42 Dishwasher

    Cheers Franz will do

  • Author
    Posts
Viewing 15 posts - 496 through 510 (of 1,251 total)
1 2 3 … 33 34 35 … 82 83 84