Forum Replies Created
-
Posts
-
Re: HOTPOINT FFA74G
You can bypass it but more than likely a call back with a complaint of condesation around the freezer.
Re: Indesit IDL40S D/W
A new seal comes at the corrct length, it is slightly proud of the chanels it sits in, have you checked the bottom seal has not become unclipped and the spray arms are turning okay or are not split, i usualy change with the stainless steel lower spray arm, jj
Re: Kenwood KDW243A
Thanks guys the customer thinks he paid a fortune £300 for it had to enlighten him on his purchase, cracking kitchen as well and fitted with cheap chinese sh*&te.
Re: New Van
I’ll have to make up my mind quick, something major is brewing engine wise i’m off on holiday ina week so looking to struggle along and have a new one lined up when i get back, JJ
Re: Diplomat ADP8332
I’ve tried the toothbrush but still doing it, i’ll order one up and see if that cures thanks guys JJ
Re: Hotpoint WD62
Not obsolete for me Chris i still have a couple tucked away, they will come in handy someday i hope. JJ
Re: eezespares “^{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}$£”£${e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}^&
Found them on masterpart for £19 customer now wants me to order and fit, i’ll make a little profit but not much, oh! how i love the the internet????????
Re: Beko WMA 510
I got a module from another engoneer who kept a couple from machines that had sheared balance weights of the drum, i had checked the sump, pressure hose pump etc and was going to go back today with module, customer has phoned to say its okay now and spinning good style, i’ll keep ahold of the module as something tellsme i’ll need it, thanks chapps JJ
Re: Whirlpool S20BRSB21 A/G
Thanks i’ll pop round tomorrow its a holiday letting company, i do work for the other letting companys in the area so getting this one as well will be a little boost. jj
Re: ariston a1636
As Jim says it is an F08 fault, check the heater is not down to earth i’ve had loads going down causing this after that its either the pressure sw or the more expensive option the module, JJ
Re: Accounting software.
Been using easy invoicing for a while, only down side there is no expense part in the software at present, i looked at a few and this was the easiest to use for invoicing.JJ
Re: Hotpoint dwf60 driving me nuts, any help please
Firstly i would never use cable ties on these i always use small jubilee clips, which side did you lay the dishwasher down on, it sounds like you may have water in the pressure hose causing an air lock this will cause this fault take the hose off the pressure sw and blow the blocage out, always lay the machine on the left hand side from the front if you use the other side water will get trapped in the pressure hose. JJ
