Forum Replies Created
-
Posts
-
Re: Hoover hswd126
Hi I would suggest cleaning the condenser unit,these Hoover washer dryers are a nightmare
Re: Hoover VHC681B
Hi his job means dismantling the front of the dryer I would call someone in to do it unless you have done something like this before.
Re: Hoover condensor Vhc58 All lights flashing??
Hi it could be 1 of 3 things heating element,pcb,or front ntc the heater is the 1st thing to check you will need a multimeter to check this
Re: Hoover VTC5911NB fault codes
They have problems with these dryer as they design them for kitchens don’t know what the ambient temp should be but I deliver new 1s about 2 years ago and was told buy Hoover engineer my mate they where having the problem if they where outside so most likely the front ntc don’t know if they have modified the part.
Re: Hoover VTC5911NB fault codes
The only way to find the fault code is to plug in hoovers mem loader front ntc goes a lot on these. Check location if outside it wount work because of ambient temp. Kai
Re: Hoover infinity tumble dryer all warning lights flashing
If you test the heater there is a thermostat and ntc with wires going to them on the heater these should read 0.5ohms or around that then the front ntc should read in the region of 30-40kohms there is no way of you checking the pcb hope this helps kai
Re: hoover HNF3147-80 3100636 wont spin but washes ok
Hoover used to have 3 problems with dc machine rectifier motor or main pcb if you want to check selector but it through a test cycle if you have problems getting it going into test more than likely selector
Re: hoover HNF3147-80 3100636 wont spin but washes ok
It’s a dc machine check the rectifier these are prone to more than1 fault
Re: DCU8230 Beko tripping electrics
Hi make sure its unplugged and where the cable enters the machine there will be a mains filter that is your most likely cause easy to change hope this helps you kai
Re: Hoover infinity tumble dryer all warning lights flashing
Poss 1of 3 things pcb,heater or ntc probe you will need a meter to check these I would check the heater 1st
Re: siemens wm14p160gb03
Yes it will need programming but all the Bosch modules I’ve ordered come with instructions on how to programme. Kai
Re: Hoover VH W854 D washer dryer flashing door lock
My advice is to do a insulation check on machine with all the wires connected to the pcb and disconnect 1 component at the time until you find faulty component. Kai
