Forum Replies Created
-
Posts
-
Re: Masterpart
When I 1st started repairing I used maddocks which are close to me but I found them unreliable and expensive compared to connect and hard to find parts I haven’t ordered anything for 6-7 years with them another company that is similar is homespares I haven’t ordered with them for ages either and don’t have access to the both websites so I haven’t got time to be on the phone to reactivate these accounts but still get emails with offers which ain’t any good anyway
Re: Hoover VHC681B
Ok safety 1st unplug machine remove lid 3 screws at the back and the plastic sides then there are 2 screws holding the console on,then remove door then there are 4 screws holding the front panel on,and 1 each end at the bottom of the front panel then you have 4 7mm screws to remove front panel there are 2 wires on the door lock of front panel to and then your where you need to be, I still advise you to have someone who knows how to do this as it a big job,and I wount be able to help you further regards kai
Re: Blown Bosch module
That’s what my mate from hotpoint says to me when I ask him to programme modules and they don’t programme up lol
Re: Blown Bosch module
No I couldn’t configure the power module are the Bosch display modules interchangeable as I tried another complete facia and power board without the motor plug connected and I had the start light come on and the door lock clunking
Re: Blown Bosch module
Wae28468gb/17 fd 8903 700527 have changed module and pump which caused power module to fail but I have nothing on the display have power to the main pcb,faulty display board?? Maybe any help welcome
Re: Aeg 60870 dishwasher
There is a sensor at the bottom of the sump check this have had a few fault on zanussi. Kai
Re: HOOVER DYN8144D
I had a candy w/d where the dryer was coming on no matter what programme you selected you would think pcb related no it was the wash heater if you have put a long heater in if so I would change it for the smaller part number I listed the heaters on Hoover candy machine cause a lot of problems with the programming on the pcb for some reason I hope this helps kai
Re: Beko WMB91442LW washing machine
If it’s got a brushless motor there is your problem had loads of these with same fault. Kai
Re: hoover hnwf 7137 11 flashes
Check that the dryer duct is clear and the valve operates on the dry cycle if that’s ok it probably pcb kai
Re: Candy AQ100 – went completely dead. Then came back to li
Possible a timer or heater related fault you can check heater with both a multimeter and a megga heater should read about 28ohms and pass over at least 5 mohms for the megga. You will be hard pushed to get a replacement for such a small machine, hope this helps you kai
Re: Masterpart
Well I’ve been waiting over 2 months for Bosch suspension which is in stock with Bosch uk and they keep telling me that they can’t give me a eta plus sent me a order I didn’t even place
Re: HOOVER DYN8144D
Hi what was the element you fitted if its not HVR41042459 you could still have problems and if you meged the heater and it wasn’t infinitely change it
