Forum Replies Created
-
Posts
-
Re: Candy GOC58F no heat
If all the lights don’t flash on the front and it tumbles chances are its the heater worth checked as it could be front thermostat ntc
Re: hoover vts614d21/1-80
More likely to be main pcb faulty if it’s in warranty I would leave it to hoover thou
Re: Hotpoint SDL510G Dishwasher (36685980000)
When you program a module you need to leave it unplugged for at least 2 minutes after programming the fault you explained in the 1st post sounds like the machine is going into standby so I would say module fault these new arcadia modules are a right pain
Re: Candy 590 C condenser tumble dryer
If the start pause light stays alight when you press it and all the other lights don’t flash this could be a problem with the motor capacitor somewhat like a starter motor on a car the capacitor is like a start to get the motor going
Re: Hoover WyDN855
There is only 1 motor fitted on this any machine if your not familiar with what a motor is I think it’s best for you to get someone to look at it
Re: Lg tumble cuts out
Found the problem to be display board well wires to it resolver got working fine
Re: Hoover WyDN855
If there is a fault on the motor this can affect the door lock I’m an ex hoover engineer
Re: Hotpoint WMF740 Intermittent Random failures
If the brushes are wearing uneven the motor will need replacing but I have had a hotpoint with h2o a few minutes in and the pcb was faulty
Re: hoover goc 580c-80
If pcb is gone it will need programming as I had 3 modules from connect and all the lights flash it needs to be programmed to the Eprom file not the model number this can only be done with mem loader that only hoover have
Re: Hoover silentpulse dyn166p8c
I suspect the pcb has gone so I would advise either a engineer visit or new machine there will be a 3100 number inside machine which would help on further looking into problem
