litlor

Forum Replies Created

Viewing 15 posts - 121 through 135 (of 164 total)
  • Author
    Posts
  • in reply to: Scandinova FF6745D fridge mayhem #138318
    litlor
    Participant

    Re: Scandinova FF6745D fridge mayhem

    Sounds like a poor pumping compressor they tend to get very noisy when they go wrong

    in reply to: Zanussi ZDT 6894 no fill #138293
    litlor
    Participant

    Re: Zanussi ZDT 6894 no fill

    that will do it every time

    in reply to: Zanussi ZDT 6894 no fill #138291
    litlor
    Participant

    Re: Zanussi ZDT 6894 no fill

    Simon
    Justed looked at my service bulletins 3 in 1 tabs ok and if working in garage no prob with the water

    regards

    John

    in reply to: Zanussi ZDT 6894 no fill #138287
    litlor
    Participant

    Re: Zanussi ZDT 6894 no fill

    hi simon
    taken this off TDS cd
    a) Tap closed
    b) Fill tube bended / intervention of Aqua stop device
    c) Mains water pressure < 0,3 bar
    d) Intervention of anti-overflow device
    e) Water fill solenoid/ wiring interrupted
    f) Pressure switch faulty / Wiring disconnected
    g) IWMS- pressure switch tube obstructed
    h) Central filter clogged
    i) Excessive foam
    l) Dishes upside down
    m) Siphon created in drain

    check above before changing IWMS i used to work for Zanussi and changed loads of them theres no instuctions and its a messy job, water everywhere

    John

    in reply to: Zanussi DC 970 stops cycle early & no fill #138273
    litlor
    Participant

    Re: Zanussi DC 970 stops cycle early & no fill

    when the machine stops can you hear a buzzing noise coming from the inlet valve?? if so poss valve has locked off

    in reply to: Hotpoint FHP 1000-1200 motor #137702
    litlor
    Participant

    Re: Hotpoint FHP 1000-1200 motor

    motor plug pt Number 1604976

    in reply to: Cooker Branded as Cookers #138274
    litlor
    Participant

    Re: Cooker Branded as Cookers

    ive just put in cookers on Seme only comes up with one model 600401 and only lists one part fan oven element which is not in stock

    in reply to: Phillips PKC 004 #138252
    litlor
    Participant

    Re: Phillips PKC 004

    hi thanks for reply, customer said its above 18 years old shame to lose the oven just because a couple of hinges

    in reply to: Fisher & Paykel E402b defrost problem #138163
    litlor
    Participant

    Re: Fisher & Paykel E402b defrost problem

    This a defrosting problem Defrost Heater or Defrost Thermostat open circuit or defrost timer at fault

    in reply to: Zanussi carbons #138129
    litlor
    Participant

    Re: Zanussi carbons

    The part number you got is correct 481931088529 and will do the job they are £8.99 each but you can buy the same carbons the pair from seme as above

    in reply to: Zanussi carbons #138126
    litlor
    Participant

    Re: Zanussi carbons

    part number W1-18105/A £4.75 2 in pack from SEME

    in reply to: Bosch Fridge Freezer – Handles Breaking !! #138114
    litlor
    Participant

    Re: Bosch Fridge Freezer – Handles Breaking !!

    bosch door handle you want Pt number 096109 £5.82+vat & P&P

    in reply to: Brandt Apollo? #138109
    litlor
    Participant

    Re: Brandt Apollo?

    I think the black thing your talking about is the compressor and yes this does get hot usually when some one removes ice with a knife they put a hole in the evaporator depends if it is a bonded one its not repairable if you can replace it but will cost loads.

    in reply to: AEG BH884 OVEN #138050
    litlor
    Participant

    Re: AEG BH884 OVEN

    washvac’s have got then in stock £15 22 +

    in reply to: Zanussi FLE1216W Skipping prog’ #136988
    litlor
    Participant

    Re: Zanussi FLE1216W Skipping prog’

    have we got a fault code

Viewing 15 posts - 121 through 135 (of 164 total)