Forum Replies Created
-
Posts
-
Re: indesit w123s error code 8
AndyMitchell wrote: Any ideas?
More than likely it is a motor problem or connections between the motor and module (to connector block “CNE” on Module)
Unplug machine completely from the mains before attempting any inspections!
Martin
Re: Heat sheets. between cooker and hob?
The larger B&Q Stores stock heavy duty aluminium cupboard lining. Sold in sheets and can be cut to fit. Perfect as a reflective shield in wooded (MDF) oven cabinets!
Ask in their Fitted Kitchen Department 😉
Martin
kwatt wrote:I have to say that the very thought and the mental picture painted is not very appealing. 😉
Yeah!…you’re right, perhaps I should get a haircut 😆 Oh how I wish I had a head of hair like Dave Conway has 8)
MartinRe: Avatar Images
How do you like my new ‘Bermuda Shorts’? Just for the summer you understand 😉
Martin
Re: Incontinent Ariston Margherita 2000
Swede,
Drain Valve???? Do you mean that the water is constantly flowing out as soon as it comes in I wonder?
I suggest if that is the case to make sure the outlet for the machine is above the water level. To prevent syphoning as it were. Usual rule is at least 50cms above floor level 😉
If by Drain Valve you mean Water Inlet Valve keeps filling, then you need a new inlet valve 😉
Hope that helps?
Martin
Re: Citroen Relay
I have been driving Citroen vehicles (cars that is – Drive a Vauxhall Astra Van) now for almost 20 years. Currently have a Citroen C5 which is fine. BUT I did have problems with it a short while back and happened across the local service Manager for Reg Vardy Citroen. At the time I was in his house fixing his tumble dryer, and happened to enquire what he did for a living etc etc.
I then told him of my slight problem with the car and he admitted that at present Citroen UK were in dire straights over servicing due to the lack of spare parts. Spare parts supply from France to the UK is the main problem and they have been experiencing this situation for months and months.
Later he said it would be probably as long as 5 weeks in getting the part for my motor (that was in March) and the part arrived 3 weeks ago, so it actually took 13 weeks.
So, Citroen vehicles?…………..there fine, but buy 2 so you have a spare one when the other is laid up! 😆
Martin
Re: Diplomat Oven Repair
Foxy195 wrote:However, on another note, I have a Bosch washing machine its a Classixx 1200, we brought it in Oct last year and since then the final spin has become much louder that it originally was and it doesnt seem to wash, spin aswell as it did.
Foxy,
Do be careful not to ‘over suds’ the machine. Bosch machines don’t like too much detergent using as they foam like crazy and its hard to rinse away. Especially using ‘Quick Wash’ which is best avoided when you’re washing towels etc that need lots of rinses anyway.
Check the pump also (see instruction booklet for access info) as you may have a button rattling about inside it? 🙂 Make the usual checks then try it again. If its still noisy, give Bosch a bell as its under guarantee 😉
Martin
Re: Bosch SRS4602GB/13 Module set up
WhiteBoxMan wrote:All SRS / SGS ( 45 / 60cm ) range dishwaher pump impellors are accessable through a small cover held in place by a TX20 Torx bit ( except plastic based 60cm ). The cover is located in the sump, remove the fine & coarse filters and the screw is located at the “7” oclock position ( not ten ).
Just been reading this thread again and thought I would pick up one very small point here. I have not as yet come across many SRS series dishwashers, but the ones I have seen DO NOT have access to the drain pump from inside the tub 🙁 No little plate held with a Torx screw like the SGS series has 😕
Martin
Re: Bosch SRS4602GB/13 Module set up
CJ,
I refer you back to my previous comment:
Martin wrote:‘Independants’ (such as the majority of us on this site are after all) do represent the backbone of the entire field service industry. And I can assure you the ‘publics attitude’ to us is one of complete gratitude and support, in deference to manufacturers own service.
Many manufacturers are now coming to us ‘Independants’ to take over their ailing, mal-administered service networks. A certain ‘Italian sponsored’ British company is currently advertising nationwide trying to bolster its declining workforce by offering dodgy franchise contracts to independants. Just who is the ‘sheep’ and the ‘wolf’ here I wonder?
Martin
Re: indesit w123uk module fault?
gary38
I’m pleased you managed to establish a repairer. Indeed we have dealings with QER Ltd, they are generally a Trade Only repairer but have been known to help out anyone in need 😉
Martin
P.S. Love your Avatar by the way, very original 😆
Penguin45 wrote:Martin – we need an archive of the retired avatars otherwise this thread will make no sense at all!
I dunno what you mean?…. It’s only Dave thats just had his picture took, thats all 😉
…..and he’s already been archived 😆
MartinRe: Bosch SRS4602GB/13 Module set up
CJ wrote:what does this saga say about the publics attitude to a lot of independents ?
Easy CJ,
Lets get this thing into perspective here for a moment please. 🙂
‘Independants’ (such as the majority of us on this site are after all) do represent the backbone of the entire field service industry. And I can assure you the ‘publics attitude’ to us is one of complete gratitude and support, in deference to manufacturers own service. 😉
Martin
Re: Avatar Images
Dave_Conway wrote:Thanks Martin – I think 😉
Dave,
Rest assured that it IS you 🙂
(actually taken from a photograph of you as you crossed the car park at Sibson a short while back 😉 )
Enjoy the accolades from all those that know you 😆
Martin
Re: Bosch SRS4602GB/13 Module set up
Martin wrote: But I am sure it simply something caught in the drain pump
Nice one Robert………. 😉
Thanks for the up-date !
Martin
Re: Independents Are The Best!
In the UK National Census 2001 it was established that almost 20{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the entire UK population live within a 30 mile radius of WOLVERHAMPTON (Postcode Area : WV)
No-one is listed on UKW to cover this vast area though 🙁
Martin
