Forum Replies Created
-
AuthorPosts
-
Martin
ParticipantRe: zanussie zk1245 prod914606103 01
Contact your local Serviceforce dealer who will order it for you. 💡
Martin
ParticipantRe: zanussie zk1245 prod914606103 01
1325229407
Martin
ParticipantSiemens SIWAMATXLI1240
ChrisR wrote:I was told it is the ENR number.
Not so Chris. You have these to choose from:
WXLI1240GB/01
WXLI1240GB/10
WXKI1240GB/14
WXLI1240GB/17
WXLI1240GB/18
WXLI1240EU/01
WXLI1240EU/10
WXLI1240EU/14
WXLI1240EU/17
Or
WXLI1140EU/18That number is on the inside of the door and on the back panel adjacent the mains cable inlet.
August 16, 2015 at 3:31 pm in reply to: Candy GrandO drains, but times out displaying E03 error code #429603Martin
ParticipantRe: Candy GrandO drains, but times out displaying E03 error
An earth leak on the heating element can cause random E:03 errors.
Martin
ParticipantRe: BEKO DG582WP grill door gas saftey cut-off device
bepcooker wrote:Can you clear me your questions?
What ???
Martin
ParticipantRe: Siemens SIWAMATXLI1240
As you probably realise giving the ENr number is essential in locating the correct part you seek. It could be pump part no: 00144979 but to be sure give us that all important number first. 😉
Martin
ParticipantRe: Hoover H160E stops mid cycle, during spin
Brushes.
Martin
ParticipantRe: Zanussi ZDTS101 – Anti-flood warning
CraigZan wrote: Is it possible that a pipe has simply become unattached?
Very unlikely. Don’t forget we are talking an internal leak where the anti flood device has come into play thus preventing any water escaping the appliance and going onto the floor.
Martin
ParticipantRe: AEG LAVATHERM 57720 ELECTRONIC start/run problems
An error has occurred with the main circuit board. 🙁
Martin
ParticipantRe: VT914D22X/1-80 e07
No earth leakage at all is there?
Wiring between interlock and PCB OK is it?Martin
ParticipantRe: Zanussi ZDTS101 – Anti-flood warning
Remove inspection panel and clear the water from the base tray, then try and locate source of leak or overfill.
Power disconnected first don’t forget….!! :zap:
Martin
ParticipantRe: JLWD1609 Help Access to pump
Access pump from underneath after removing baseplate. Sod of a job….HAVE FUN…!!!
Martin
ParticipantRe: Zanussi ZWD12270W1 (91460402802)
Wire to NTC on condenser has come adrift.
Martin
ParticipantRe: bosch was32461 clothes still wet
Small loads of ‘heavy when wet’ will never distribute correctly. (One bath towel for example). So it will never complete a cycle and spin correctly. 4 or 5 bath towels, no problem.
If unbalanced is NOT an issue then the time it takes to drain the rinse water will be to blame. Bosch are natorious for drain pipes getting gunged up. Like blocked human arteries trouble isn’t far away.
Try testing how quickly the tub drains on a rinse and spin only cycle WITHOUT any washing in. A full rinse tub should empty within 45 seconds or less.
Martin
ParticipantRe: bosch was32461 clothes still wet
Restricted drain issue? Have you checked the drain filter lately?
-
AuthorPosts
