Forum Replies Created
-
Posts
-
Re: WTE6920GB/05 Dryer
Replace the front NTC should cure. Manuals in .pdf downloaded via Bosch website.
Re: Miele 5191 poor cleaning
Garryl wrote:there is a powdery feel and look to everything
Classic symptom of insufficient water either not filling with or not circulating properly.
Re: Hoover Logic 1000 – A3670. Renewing the suspension
Well Mike, molegrips and spanner are the only way short of hacksawing the rod off that is.
Re: Dishwasher powder in the salt reservoir – what happens?
Detergents chemicals can easily filter into the resin ion exchanger unit, clog the resin crystals and render the whole softening unit useless.
Re: zanussi fr1250 914516007
wellsm122 wrote:Great is there part number I can order, unable to find it on the parts site
You’ll need to first establish the make of motor as there are 3 types fitted. Best you take the brushes out first and compare. Or if you have a local repair shop, take a brush unit in for a like for like replacement. 💡
Re: Hoover dishwasher
NTC seems OK but wouldn’t give you a no heat fault anyway. More likely is a PCB issue or the wiring harness broken?
Re: Bosch WTA3200 not drying on auto cycle
Valvo wrote:Do those readings appear within spec?
Dunno about within spec but clearly the NTC resistance varies as the temp varies. As a new one is relatively inexpensive I would advise replacing it anyway.
Bosch WTA3200 not drying on auto cycle
A heat gun?
It is 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} Bosch made by the way. Not Crossley.
Re: Hotpoint Dishwasher BF71
ColinD wrote:Gents,
Will the fairer sex not benefit from this snippet of wisdom and luck also?
Re: Bosch WTA3200 not drying on auto cycle
Its an NTC that it’s readings are in Kohms. Heat in one direction is normal.
