Forum Replies Created
-
Posts
-
Re: neff S5453X0GB troubles
Try resetting the program. To do that, press the On button then simultaneously press the 2nd & 4th program buttons. Close the door and the machine should drain for 1 minute then switch itself off. Open the door and then try selecting another program. Fingers crossed!!
Re: Hoover washing machine door lock won’t engage
Certainly you will need to check if the electronic programme circuit board has been damaged (it sounds as though it has). Then locate the component that caused it to blow ( i.e. Motor, Heater, Pump etc).
Good luck but be safe and unplug from the mains first 🙂
Re: Bosch WVT1260GB/01 Dryer Section Not Heating
Not a chance, so be sure and take clear photos of those wires 😉
Re: Bosch WVT1260GB/01 Dryer Section Not Heating
Sparky67 wrote:My wife, who usually drives it, says she has had to switch it on and off to get the dryer to work in the past, but I can’t get it to heat up at all…
It could be then that the dryer control is at fault. It switches on the neutral side so that would explain you getting 230 to the heater and stats.
Re: Bosch WVT1260GB/01 Dryer Section Not Heating
Push the red reset button on the stat on the heater duct :tup:
Re: Candy Smart touch washing machine series – any good?
As I mentioned earlier they will sell like hot cakes. Any excuse to add an app to your smartphone. With Candy you can:
Have smart check-up
Optimise your washing habits
Voice assistant, smart cycles and so much more. Even add 40 extra programmes. Set it to finish when you want it to.
Oh yes, we’ll all want NFC stuff. Soon if it doesn’t have it they won’t buy it. 😉One small step for man, one giant leap into the future….
Re: replacing water level switch on Hotpoint washing machine
andy_from_ireland wrote:I like tinkering :tools:
Priceless! :rotfl:
Re: Candy Smart touch washing machine series – any good?
…..but rest assured they will sell like hot cakes AND, and any weaknesses will keep the repair trade occupied.
So everyone gets the Candy :tup:
Re: Smv50c00gb13
Very common problem with these machines and loads of posts on the subject. Now if there is a water supply issue ( i.e. insufficient water flowing through pump) the element will quickly overheat and fuse. So the water diverter could be at fault or the heater relay on the power board stuck on, take your pick. 🙁
Re: SiemensSN26M853GB/44 FD 9109 dishwasher
E:04 is one of 5 errors (incl. E:01, E:02, E:03 & E:05) that refers to a faulty power module. 🙁
Re: Hot & Steamy: AEG Washer Dryer : 91460610701
Hot ‘n steamy got to be either no water flowing through the condenser or the condenser itself blocked with fluff. Tricky to access but OK once you fiddle getting the fan motor off.
Re: ZWD1271W
Change the smaller of the two pressure switches as that is the one more likely to fail. 😉
Re: ZWD1271W
It will fill with far less water when no clothes are in the drum. The amount of water it fills with are directly related to the level of load.
The problem you are experiencing is NOT that it isn’t filling with sufficient water but more likely that the circulation wash pump is not pumping water into the drum. The usual reason is that the water nozzle/hose that pumps water into the drum from the top of the door seal is blocked with gunge so no water is circulated through the clothing as it tumbles.To check that simply observe through the door glass for the cascade of water emiting onto the clothing as it tumbles. Can’t see any water? then it is a blockage needing investigation. 😉
