Forum Replies Created
-
Posts
-
Re: ISE 10 F1 fault.
Hi Jim, Just checked my own 1406W and the impeller turns 180 degrees.
If all else fails, there is always THIS to try!Re: Fault Code Guide
Instead of separate ios and android etc programs, why not just use a php/MySQL web page with member access rights with, apart from fault code database lookup, a facility to submit new or unrecorded codes for approval.
That way any smart phone with a browser could access the info.
Just an idea 😕Re: CI555WH headscratcher???
Have you checked motor readings at the pcb end Jim? sound like o/c motor/ broken wire?
Re: Hoover WMH147DF – Button Panel
Thanks for the reply Martin.
The problem is that the start button has broken of the housing, which is all one moulding with the other buttons.
Bit of a devil if it comes only with board that just clips in though.
Martin(2)Just had an F1 and F3 fault
Found molding fault in sump hose – branch to pressure switch blocked off with rubber!
Problem removed (no comments please!)
The F3 Problem – pump impellor
Re: 1607W display
It appears she just had one heavy item in it so the nine bars displayed must be informing out of balance load.
Cheers,
MartinRe: Induction Motors
Two phase – the capacitor is there to create a phase shift and the value of the cap determines the amount of current for the 2nd winding
Re: ISE 1406 – how to get coins out of the drum….
Put screwdriver down centre hole in paddle the apply sideways pressure while pulling paddle forwards
Re: Whirlpool AWO/D 4505 859233215000
Could be resistor R020 on the control board.
It’s a 22ohm 2watt wirewound.
I’ve had a few do this.Re: Belling dishwasher lower door seal IDW602/2
I had one where it was leaking badly from the door – it turned out one of the spray arms split at the seam
