Forum Replies Created
-
Posts
-
Re: Bosch SGS4472ZA/17 FD8403
Probably not related, i went to a Siemens diswasher that had blocked pipe ( the usual one at the bottom at the front) It registered a fault.
After cleaning i went to set it and the customer pointed out when you now set it the numbers in the display for minutes was all wrong, way higher. when i pressed the 2 buttons to reset it then went back to normal.
Re: Why is it….
washdoctor wrote:
allan73 wrote:
I could have refused to carry on with the work at that point but as I say i know her parents and i trusted her to keep her word…… 😳Lol! Doing work for friends / people you know or family is the worst a! They abuse us more than Joe Public!
Ade 🙂
Don’t forget about neighbour’s either. One of my neighbours had a sock stuck in her machine. Got it out and only charged her 20 euro. “I’ll drop it down to you” . This is about a year ago now and every so often she says to my mother ” Oh i must drop that 20 down to Michael” :rolls: . Anyway it’s not worth the aggro to fall out with neighbours…
But it’s funny the difference in neighbours though. Her next door neighbour hadn’t money on him after doing a repair. Next day he actually walks out in front of me nearly getting knocked down to stop me to pay.
Re: Why is it….
allan73 wrote:Why is it…..I’m still waiting for 25 pounds for fitting a set of carbons in a beko washer ( i quoted 45 customer says ” i’ve only got 20 can i drop the rest at your shop tomorrow” )
Despite leaving several messages that was 2 weeks ago and no response……….. 😡Well at least you got 20, case 1 i wrote is about brushes i put on a Beko and didn’t get a penny 😡
What i also find interesting about these type of people they will expect you to drop everything for them, call Sundays and bank holidays too and phone late at night.
Re: A small tip
Yes. for the dryer side of the inlet valve there is a restrictor and there is one where the black pipe goes into the dryer condensor( i think that’s what it’s called?)
If there is no restrictor on the inlet valve and there is good water pressure in the house the black pipe will split where it goes into the condensor 😡 😡
Re: Credit Card Scam
Happened me a few weeks back. I went over to the states to find my card wouldn’t work. They copped straight away and blocked it but caused me huge inconvenience when over there. Apparenty it was used in a petrol staion a few times in the Lebanon!
Re: Beko WMA520 won’t reset
Yeah when the brushes go it does the same so if you disconnect the motor it wil behave the same. I went to one of these yesterday apparently blowing the fuse in the plug. When i get there he explains ” It was blowing fuses so i tried silver paper around the fuse to get it to work” 😯 😯 . It was also tripping the switch etc. So when i get there it doesn’t work at all, with all the trying he must have fried the board :rolls:
Re: Hotpoint WF 840
Lol, yeah i meant neighbour. Haven’t looked at it yet she isn’t back until afternoon so can’t if it’s doing any of that yet.
Re: Beko dcrs 68 w ( i think)
Thanks for the replies. The fan is a little noisy too it has a little play on it, hardly would cause that? Regarding the sensor it cuts off even on the timed section, thought it wouldn’t use the sensor on that?
Re: Beko dcrs 68 w ( i think)
Sorry i meant the machine. You switch it on press the start it starts and after about 4 or 5 seconds it stops. If you switch machine on and off it repeats.
Re: Another weird WD440 fault
leavemetogetonwithit wrote:I still remember thinking the 95 series were rubbish. Jim probably remembers thinking the 18000 series were junk. 😆
Mike.I called to a Hotpoint washing machine the other day that was 24 years old! I don’t think the WMA’s from 2002 were that bad, a lot better than the newer WF’s, WD’s.
Re: Miele G 638 plus diswasher
Not too familiar with this machine. How do you retrieve the fault code on this machine?
