Forum Replies Created
-
Posts
-
Re: Classeq Eco 2 renovation. Advice please!
If its the type with the rotary pumps that squash against a short tube inside,then it may be just that needa replacing,as for the valves,you can use aquarium pump one way valves,cheap at around £4 each or less…
Hope this is of use to youMartin
Re: Hotpoint ultima WT741 Door Error – Mid Cycle – Help need
Possibly the door lock, or heater i would have thought?
Sent from my iPad using TapatalkRe: Dyson DC44 water damage help required
If it was running at the time it entered the water, then it may be beyond repair, but if it was switched off, then i would suggest removing the battery, and then leave the whole unit to dry out for a good few days, then try it again….you may be lucky!
Martin
Sent from my iPad using TapatalkRe: Miele W698 parts list
You may be lucky when you take the top off,to find a diagram of the machine tucked away on top of soap drawer,if not there its usually behind the front panel.
It could well be the inlet solenoid,or it could just be a kink in the inlet hose.
also check the small filter in the solenoid when u unscrew the hose
Martin
Sent from my iPhone using TapatalkRe: sherwood micro glass washer
No other ideas,sorry.
The only ones i have dealt with have the rotary type pump that squashes a small rubber tube as it revolves!
Sent from my iPhone using TapatalkRe: Miele Washing machine excess suds
Also if you download the manual there is a way to program them to take in more water,both for wash and rinse cycles…other than that it could be the water is to soft!
Good luck with it
Martin
Sent from my iPhone using TapatalkRe: Miele Washing machine excess suds
Maybe a couple of service washes?
Martin
Sent from my iPhone using TapatalkRe: sherwood micro glass washer
Also check the one way valve that is on the feed end of the hose,..i have replaced these with aquarium pump valves..! About £2.75 each
Sent from my iPad using TapatalkRe: sherwood micro glass washer
Ive done maybe half a dozen or so of these machines with similar problems…for me it was a case of replace the rotary pump, or open it up and replace the small rubber hose that gets squeezed as it rotates..
Martin
Sent from my iPad using TapatalkRe: Hotpoint WMA 13
Thanks iadom, managed to do it using that diagram, but looks like i have 2 duff boards with me!
Sent from my iPhone using TapatalkRe: miele motor
Pretty sure all motor 37’s are the same. Fitt all the 700 and 800 range for sure and good up to 1200 spin me thinks…
Sent from my iPhone using TapatalkRe: bosch dryer
If you are refering to the fan cowling,then this should unclip from underneath the machine,allowing access to at least the right hand wheel!
Sent from my iPhone using Tapatalk
Re: MIELE NOVOTRONIC MODELW504
Does the drum rotate?
If not it may be the motor brushes need replacing?
Sent from my iPhone using TapatalkRe: Miele W304 – Drum Spider Change
Also mark the exact spot that each of the four top drum support springs fit in to, as if you get this wrong, you will find the drum front will rub on the door seal on spin cycles…
Also no special tools needed for removal of bolts, you can probably get at the drum without removing the cast iron bearing holder as well
Sent from my iPad using Tapatalk
