Forum Replies Created
-
Posts
-
Re: Neff DW S5453
Hollytree_Technical wrote:For every 1 that I change the impeller jug in I clean 20 pressure chambers – it could be either but in my experience it is mainly just a case of taking the pressure chamber out and cleaning it.
Jem
The impellor jug appliances are later models and have different pressure chambers . I’d say this fault – because of the ‘check water’ light – will be an impellor jug replacement. 😉Re: Bosch F/I WIS24140GB/20 Fault code
Does the pump come on ? Think its water in base – F:23 error . HAve they opened the drain pump lately ?
Re: Neff combi oven C67M70SOGB
E300 – incorrect module combination i.e display control module . If you havn’t changed any boards i’d agree with DrDill that it may be the power cuts causing board confusion .
Re: Bosch taking to long?
It will wait for approx 105 minutes before moving on for a no heat fault .
Re: Neff Dishwasher Model S5555XOGB/79
The impellor jug measures flow rate and sends this info to the main control module. The module then uses this info to determine how long the valve remains open for . I.e if it needs 10ltrs of water and the rate is 10ltrs a minute , it’ll open the valve for 1 min. If it gets a false or no signal , the valve remains open unitl it ‘overfills’ , pumps out some water and then starts filling again…..hence the continuing fill/drain/fill/drain cycle it gets stuck in !
Re: Neff hob & oven- Intermittent Sparking
Your oven and hob are 2 seperate entities . That is the oven model number . You will need the hob number which is normally stuck on the underneath of the unit .
Re: Siemens wm14e141gb/09
close door – switch selector off – wait a couple of seconds – turn selector switch to position 8 ( bottom setting ) – hold spin speed button and turn selector switch one click clockwise (position 9) release spin speed button – error memory shows – reset switch selector back to off .
This should clear the error and release the machine .
Re: Neff Dishwasher Model S5555XOGB/79
WhiteVanMan1 wrote: It fills ok, so it can’t be the impellor jug, …….Any ideas please? Cheers. Steve.
A faulty impellor jug doesn’t stop the appliance from filling ! It will normally cause the machine to constantly fill then drain then continue filling then drain abit forever . Does the tap symbol appear on the display after approx 20/30 seconds ? Pound to a pinch its the impellor jug 😉
Re: bosch wte8430gb/17
dopper wrote:…….pump seems to be working, anyone advise where to look at , maybe a blockage ?
dopAre you presuming this because you can hear the drain pump ? The pump sump will probably need clearing out . They are prone to collecting gunge !
Re: Bosch WM Banging
With the lid off and appliance unplugged , push down on the drum at both sides . Doesit make a ‘kedoing’ noise ? It may be that the suspension springs need lubricating where they hang on the cabinet/cross bar.
Re: Bosch sms65e12gb. e06
E0:6 isn’t a drain out fault – Its a door sensor fault – Either the connector on the door sensor has come adrift or the control board is cooked .
