[nomadPaul]

Re: Bosch WVD24520gb/01 dryer problem

Check the condensor for blockages/fluff . It may be overheating due to a blockage.

[nomadPaul]

Re: Bosch dishwasher

Make sure the mains plug isn’t pushed into the bitumen insulation on the rear of the appliance

[nomadPaul]

Re: Siemens dryer

Its a sensor dryer so no load = no operation after 2/3 mins . It needs a wet load in it to test properly and then see what indications it gives if it fails then.

[nomadPaul]

Re: Siemens dryer

Are you testing it with a wet load in it ? if yes , then I’d be checking the temp limiter first. if no , try it loaded ! unlikely to be a board fault .

[nomadPaul]

Re: BOSCH WVD245S3GB/01 ….need an expert! starnge fault

It could be a blocked condensor causing an overheat condition. I had very similar probs that took a couple of visits to suss out .

[nomadPaul]

Re: Bosch WAE24363GB/05 1 min left

The other possibility , if it happened only once , was an out of balance load where the machine aborted the spin ?

[nomadPaul]

Re: siemens wm16s797gb

Motor/brushes fault…….and don’t forget it’ll prob need resetting too .

[nomadPaul]

Re: Reset procedure for Bosch WAA24171gb/01

Scroll down on this page and all should be revealed !! Lots of related topics 🙂

[nomadPaul]

Re: Bosch Tumble Dryer

You need to check with your customer if any other lights are flashing when it stops .

[nomadPaul]

Re: Siemens stops at prerinse

Two things to check . Is the impellor access cover on properly ? If it is then you may need to check the non-return valve which is situated in the sump between the drain pump and drain hose . A foreign object/blockage in the non-return valve , stopping it from closing corretcly can cause E:24 faults.

[nomadPaul]

Re: Neff U146IN1GB/07

Did you fit the right hinges ? Top and bottom door hinges are different part numbers . Also , check if the door is ‘flat’ when fully open . If it goes past the horizontal , the hinge bearings may be faulty .

[nomadPaul]

Re: Siemens washerdryer not drying

I’m not 100 {e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure but I think the condensor valve on these models may ‘cycle’ so not energize straight away but may take a few minutes to operate .

[nomadPaul]

Re: Siemens WT79020GB/04

Are you testing it with a wet load ? If tested empty on a sensor dry , it could be ending the program just because it thinks its all dry .

[nomadPaul]

Re: siemens IQ 1430

It’ll be a WIQ

[nomadPaul]

Re: Bosch Gas Hob not lighting

daveg1980 wrote:Got it – hbn2850gb

Dave , i believe this is your oven model number ! I’m guessing you have a Bosch oven built in underneath the hob and this is the number you’ve read . You will need to pull the oven out and look under the hob to find its ENR .

[Author]

Posts