Forum Replies Created
-
Posts
-
Re: F&P GW709au over filling
That fault is change of water level not detected in time allowed. Standard fault is the tube being trapped, kinked or holed. It should not have any water in it at any time.
Other possibilities are the level sensor itself or the motor controller board, but these are unlikely in view of there being water in the tube.
Fully drain the machine, remove tube at top end and blow clear, refit and test.
Power off, of course……
Regards,
Penguin45.Re: Humming Pump on Electra AWM 900B
Does this machine empty into a “stand pipe”, or is it coupled to a spigot under the sink? If the latter, these are so and soes for choking up and restricting the water flow. The pump motor then cooks itself……..
Regards,
Penguin45.Re: indesit we16
So. “Lucky” isn’t your middle name then…..? Computer board is p/no C00093628 – £80 odd from memory, plus the Vat etc… Plus – why has it blown? – If you wish to keep the machine going, I would certainly replace the door lock at the same time.
Email to spares@ukwhitegoods.co.uk quoting part number for confirmed prices and ordering.
Regards,
Penguin45.Re: INDESIT W161UK NO HEATING
Heater is operated by a relay on the computer board. These fail regularly. Dry solder joints on the board are a regular fault. Also, regular problems with wiring in the heater/thermistor area – the wiring breaks inside the insulation, so nothing to see – continuity testing required, also pulling at the connectors at the same time.
Penguin45.
Laserlight wrote:
Can you tell me what does water inlet have to do with tumble drying?Have a read of this:
http://www.ukwhitegoods.co.uk/modules.p … age&pid=52Regards,
Penguin45.Re: smartdrive 051 short pulses of water soleniods,wont agit
131 is specifically a motor position sensor failure. It can be just wiring, or motor controller board. Sensor is p/no 425221P and is probably the place to start.
Regards,
Penguin45.Re: SMEG website
What’s special about it Paul? Sure I did one of these a couple of weeks back and a standard small/small end drain hose went on with no problems?
Chris.
Re: Zanussi ZX99/5
7 different versions of this model, oh Pink Spotty one. Please post up the pnc number starting “928********” and I’ll see if I can narrow it down for you.
Regards,
Penguin45.Re: indesit we16
P/no C00011140 or C00085194 are suitable locks for this appliance. An email to spares@ukwhitegoods.co.uk for prices and ordering.
Regards,
Penguin45.Re: Stupid, more stupid and MFI sales assistant
Nice to see that the good old “British Shop Assistant Syndrome” is alive and well.
Chris.
