Forum Replies Created
-
Posts
-
Re: Miele KTN4352 Alarm
Ask the lady what is the fault code (F?) it shows when its in alarm state.
Most likely is that its a temp’ probe failing, sometimes they take in moisture & this shorts the sensor. After drying it, a rub of silicone around where the cable goes in to sensor seems to do the trick.Re: AEG L74650 not filling
Go into service mode, fill with water & empty again.
This seems to reset the level sometimes.
If level is not at zero at the start of cycle it will not take in water so basically it will run pump until level is detected at zero level.
Worth checking for blockages in drain hose pipe, sump hose etc.Re: Beko DRV5 62W tumble dryer staining laundry
Front felt bearing & bearing pads will likely need replacing. You need to clean front of drum also where it had rubbed off felt .
Re: AEG L12710VIT – 914601223/01 E36
Likely to be the dryer element thats causing this, so try disconnecting all wires off dryer element, try wash programme again & it should be o.k on wash settings. Have had quite a few like this, check dryer element & you will likely find its low down to earth.
Re: Beko DWD4310 d/w not filling
Overflow switch or warped polystyrene float are the most likely things to be causing the problem, have had lots of Beko’s like that. Otherwise cable connections onto board or flowmeter.
Re: Miele G 1022 i cutlery tray
Dearer machines have cutlery tray on top. If you didn’t pay for it you don’t have it.
All the dishwashers have the rails in place on the carcase of appliance but obviously they are not fitted to the cheaper dishwasher.Re: Zanussi zsf6150 not heating/ pcb problem
Contact Service Force, you don’t need the fire brigade turning up.
Re: Miele G692 plus – tabs not falling out from dispenser
Tablet doesn’t need to drop out, door only needs to open by 15 degrees , the water goes in & washes tablet out.
Problem you describe can be because filter is blocked or spray arms are blocked or prevented from turning because of badly loaded crockery, pans etc.If you can afford it then perhaps you should try Finish Quantumatic ..
