Forum Replies Created
-
Posts
-
Re: stoves df600
Sounds like a faulty selector switch or perhaps its as simple as the knob has moved on shaft & is not off when it shows in off position.
Re: ZANUSSI ZDC 67550W dryer wont start?
From the picture of the fan, it looks as if the filter hasn’t been cleaned as per instructions, check other fan for build up of fluff or blockage.
Does drum turn easy by hand or not, drum rests on 2 wheels which could be seized.
The motor should have a spring pulling it down, keeping tension on belt. If you take off the spring, thus untensioning it, will it start?
Check for movement in motor bearings, bearing failure is a possibillity too.Re: Zanussi ZWD1681W drain pump
Have you checked that the hoses are’nt clogged, hose from tub to pump & drain hose from pump.
Pump should be bayonet type fit, theres a lock clip holding it which when moved slightly will allow the pump to be unscrewed from filter housing.
Sometimes theres a rubber band or threads etc wrapped around impellor causing problem described.Re: tricity bendix aw 1000 long cycles
Could be that it is not heating, or could be that its slow to fill or slow to empty.
Check that drain hose isn’t pushed too far down pipe as it could be syphoning water out as it fills which is quite common for them.
E’Lux on Longmile Rd’ of your capital city can supply any parts needed.Re: Zanussi ZWF12070W1 Door Will Not Open at End of Cycle
Door lock device needs changed, they have been replaced by a better type of interlock.
Re: Here’s One For the Miele Wash M/c Experts.
It should do the job. Don’t forget to charge well for it though.
I find these Miele customers are aggrieved if they aren’t charged plenty
😆Re: a damned zanussi zwf12070w1 – e13
E31
Electronic pressure switch circuit faulty (frequency of pressure switch
signal out of limits)
Electronic pressure switch; Wiring; PCB faulty.
Cycle blocked with door closed. RESETRe: Miele Dishwaser G1270SCV1
Does dishwasher fill with water? Check that wash pump turns easy with flat screwdriver on end of pump shaft.
Have a few wash pumps in stock, if you need one PM me.
Re: Miele G653 SCVI Pluse
Couple of possibillities, first that its not filling & secondly that it is filling but circulation pump blocked so not washing. Quite easy to split the wash pump & remove any blockages.
Re: Zan ZWF12070W1 Auto Overheating?
Would be trying a new NTC first. Theres a heater in it with fuses in line so you must replace with same, check part num’ on flange of old heater to be sure. NTC not listed as spare on its own but comes in new heater. Board could also be at fault though.
Re: Leisure Roma 100 Range cooker – Thermal links in wiring?
Manufacturers are now recommending that kit 4410101001 is fitted which includes thermal cut-out 210110544 & cables from terminal block to cut-out & from cut-out to selector sw’/thermostat.
Re: would a tri ben aw1402 drum transfer to a zwf12070?
Sorry misread the thread, thought you needed to know if motor would fit a motor.
AW1402 had 2 types of welded tubs used .
1268576400 & 1268576418
ZWF12070 used a 1268576301
As there were 16 models of ZWF12070 made its probably best you search with PNC num’s.Try searching here..
http://www.aeg-electrolux.co.uk/node334.aspRe: electrlux ewf14108w
Have had these with motor plug wiring broken inside the insulation, very hard to find problem. Also had inverter board damaged by tub knocking against it.
