[Seamy]

Re: commercial miele washer

rinse led flashing normally means no motor action/drum stuck, sometimes brushes worn & sometimes pcb fault

[Seamy]

Re: Beko D531 Thermal Cutout problem

210110544 is available in the shop on here, try putting the part num’ in to search box.

[Seamy]

Re: Beko D531 Thermal Cutout problem

210110544 is a thermal cut-out thats been fitted to a lot of Beko cookers, its the button type that takes 2 spade cable connections as opposed to the thermal fuse crimped wired type.

[Seamy]

Re: AEG 86730 C9(error code)

Hold in pre-wash & soak buttons while turning control knob to gentle spin position.

[Seamy]

Re: zanussi zwf1207wi interlock wiring

Again its best if you post PNC num’ as there are 7 ZWF12070W1 models, wiring of black door interlock is Black to C (common) Grey to 1 & Orange to 3.
Hope this helps.

[Seamy]

Re: zanussi zwf1207wi interlock wiring

PNC number required as this is not a valid model

[Seamy]

Re: Amica non-display fault codes

No display, i’ve had this a few times, replaced boards and its cured problem

[Seamy]

Re: Miele W844

they should be ok, they will bed in

[Seamy]

Re: old’ish model. belling cooker. fan motor part No.

Motor Unit (STC Heynau/Plaset ) 632422

[Seamy]

Re: Zan Integ oven ZBD903w fault code 003

Meat probe fault or wiring to meat probe

[Seamy]

Re: beko wm 510s not spinning

Unbalanced load will prevent it from going to full spin

[Seamy]

Re: Zanussi Z56/3W – fridge no longer chilling properly

Sounds as if it needs regassed or compressor is failing.

[Seamy]

Re: Liebher temp display is wrong

Have you tried defrosting it completely? Even if its an auto defrost type it might have got out of sync in regard to the defrost cycling, this could have happened by the door been left slightly open for a long period fr instance & just has a build up of ice.

[Seamy]

Re: beko wma510s not moving through wash sequence

Maybe filter blocked & machine not emptying all water or appliance drain hose too far down waste pipe & is syphoning on next fill.

[Seamy]

Re: belling 646hsi wiring diagram needed please.

Is there a 9 digit product numer on the machine?
Not usually a lot of tech’ info for them, just part lists .

[Author]

Posts