Forum Replies Created
-
Posts
-
Re: Beko TZDA627 Frost free Tall Freezer
If you left the door open I suspect it overfrosted in the freezer section. I would imagine if you were to defrost ( which I see you have done) and switch it back on it should work, its not instantaneous & won’t be cold enough to store food until overnight at least i’d imagine.
You should see the temperature display drop after its been running an hour or so.
Check the condenser at back to see if it is it getting warm, all I can think is that the compressor has failed perhaps from running constantly for 5 days trying to get the room it was situated down to freezing point.Re: zanussi ZWD1272W
Disconnect the leads going to dryer heater, isolate(tape up). Try machine then to see if it works.
Test heater on dryer side for low resistance to earth, has been known to cause the aforementioned & many other problems.Re: beko wma767w drum not turning
8110 is not a fault code its the type of board software in the machine.
Re: AEG Dishwasher – disaffected Employee damage?
Without the conspiracy theories, the new appliance is faulty.
Ever think of ringing the service department and have them come to look at it under warranty?
The number is on the back page of your user manual.
08445610647
They endeavour to provide next day service, although this may not be possible at this time of year.Re: AEG touch control hob intermittent fault D98000VF-M
Likely its a circuit board fault or the cabling between the boards. Common problem on them but not cheap to repair if it requires boards.
Re: Miele T560C Tumble Dryer Condensed Wtr Container not ope
As far as I can remember the lid of container has a spring on it & is closed normally. When you push in the container in to place the water feed pipe comes in contact with the lid of container causing it to slide open, the water then goes in to continer.
Looking in with water container removed, you should be able to see this feed pipe.
It may be dislodged slightly or damaged.Re: Miele T560C Tumble Dryer Condensed Wtr Container not ope
Is it possible for you to take a picture of the container & where it fits in to & post it on here, perhaps someone will be able to see whats the problem then.
Re: electrolux ern2820 not cooling
For a strart you don’t need to check the thermostat as its functioning, you said compressor was on, the function of thermostat is to switch on (&off) compressor.
Are you sure the compressor is running, is it hot to touch?
If compressor running, normally the condenser should be getting warm to, may need to get refrigeration engineer to look at it if compressor running but condenser not warming.Re: JLWM1203 doersn’t heat the water – no error code
There are reinforced heaters available, which have a different coating on them.
Available in 230v 1950w 1326730007 white tipped and 240v 1950w 1326730106 grey tipped.
Heaters should be of the type fused both legs & it is not recommended to swap NTCs.Re: AEG F87000P Dishwasher Fault code
It means that the empty level position has not been achieved inside the time allowed.
Appliance takes 1 & 1/2 minutes from pump start to empty completely, if its not recognised as been empty in this time it will throw up an I20 fault code.
Look for blockage in filters, drain hose, pressure switch hose etc.Re: Miele w526
It could be, there is normally more than one p.c.b in Miele washing machines though, it could be a fault on any of them, it is time to perhaps call an engineer to inspect and test it, or if its something that you have the knowledge & capability to do.
Power off of course when doing any work on appliances.
