Forum Replies Created
-
Posts
-
Re: LEISURE COOKMASTER CM10 FCR
Most ranges listed a weight of between 80 & 110 kg, think if you said 100kg you’d be safe enough.
Re: AEG Electrolux Lavamat Model L64810 won’t start
Maybe something as simple as buttons stuck or have been pushed in too far & now not making contact with switches on P.C.B.
Or start button could be stuck in & hence the appliance won’t allow options to be selected as Start is already pushed (stuck) in.
** The selection of the options is to be carried out after switching on the appliance and setting the desired
programme with the selector and before pressing the start/pause button.Re: eletrolux ER80341
Think the fact that it had no ventilation would lead you to believe that condenser doesn’t cool & would overfreeze in evaporator & possible cause the fan getting stuck. At this stage it may need to be re-gassed too, just a thought.
Re: Electrolux esl66010
Best to post the Product number, (9 digit number beginning 911…..), there are 33 ESL66010s listed
Re: Fitting an induction hob
Hob will take the air in from the front obviously even though the fan is at the back. Its very important to install it to specifications, they tend not to work correctly if not enough airflow and go out on overheat protection.
Re: public liabillity insurance Eire
Have you tried Quinn Direct? I’m from the up North, my public liability for 5 million cover working North & South is just £150
Re: Zanussi FS 1255
Parts listed for FS1255 are
Seal 1249685007 Seal,drum shaft,35-62
Spider 50253016005
Bearings 50269560004 30x62x16(6206)
& 50269558008 25x52x15 (6205)check PNC number & post
Re: Zanussi
Quick way to determine is to see if its a split tub or sealed type. Your(ZWD1471S)has the split type so the bearings can be replaced.
Re: newworld dw60 e3
Most likely its underfilling with water & not able to keep pressure switch for heater closed. Check pressure switch pipes for blockage.
Re: zanussi zwf 16070
Likely the syphon in the conditioner dispenser is blocked, it needs to be cleaned out & put back in the correct way round. Also try cleaning the spray holes that the water comes down through on top of the soap drawer. If they are blocked with gunge then it will have problems filling water into the conditioning rinse section.
