Forum Replies Created
-
AuthorPosts
-
Simon46
ParticipantRe: Candy CPC240FFGB relay clicking
Was the module. C3 has leaked.
Thanks Bob
Simon.Simon46
ParticipantRe: margherita 2000 troubleshooting
Unplug machine. Lower end of drain/waste hose into a bucket. Let gravity allow the water to run out. Sounds like a coin/hairgrip etc jammed in drain pump impellor. Check in filter (have a towel handy as there will always be some water left in machine). If clear then possibly pump has failed.
Regards
SimonSimon46
ParticipantRe: Schreiber APM 6314 integrated fridge problem
Does the motor run continuously?
Simon46
ParticipantRe: Repairs@ Module
Got my first one! 😀
Simon46
ParticipantRe: Siemens VARIO electronic Fridge/Freezer– Help Please
Glenn check your private messages box on the home page.
Regards
SimonSimon46
ParticipantRe: Siemens VARIO electronic Fridge/Freezer– Help Please
What is your postcode?
Simon46
ParticipantRe: Smeg UK60MFX1 f/oven element
Thanks Chris. Sadly the cooker had gas connected to it. Had to walk away from this one 😥 .
Thanks anyway
S.Simon46
ParticipantRe: Siemens VARIO electronic Fridge/Freezer– Help Please
It may possibly require a modification to it. And no parts required! best to get an engineer to it. Click on red toolbox to find one in your area.
Regards
SimonSimon46
ParticipantRe: Diplomat 8702 Washer Dryer part needed
Sure its not a gunk blocked pressure hose?
Simon46
ParticipantRe: Indesit WG1234T Setting Not Working
Do you get heated water on say a 90 degree wash?
Simon46
ParticipantRe: Hotpoint Mistral Frost Free
Two things, does the fan run in the freezer compartment and when you shut the fridge door does the light go out?
Simon46
ParticipantRe: Bosch SG13300GB/01
Any broken glasses in the dishwasher recently?
Simon46
ParticipantRe: Candy CPCA291FFK fridge freezing milk
Bob, after visiting customer and unable to turn off compressor by turning to 0 unplugged fridge and restarted. Went into Defrost and has been working since Saturday. However yellow light is now flashing since monday. Fitted replacement replacement module and notice one of the electrolytic caps is a bit fat. Light had a serious mains flicker when started but passed module tests o.k. Will wait and see. Rang customer and appears to have finished defrost and compressor now whirring.
Simon46
ParticipantRe: Repairs@ Module
All working now. Will wait and see….
Simon46
ParticipantRe: Hotpoint Mistral 8596P door hinge and spacer rings
Thanks Seamy. Already ordered seperates. Did not know you could get a hinge kit. So ten seperate washers equals about thirty quid. How much is the kit, and does anyone know how many washers do you get with it?
Thanks
S -
AuthorPosts
