Forum Replies Created
-
Posts
-
Re: unbelievable customers
Down here in Wales, I’m more likely to get one of Dave’s style of customer. Never seem to get the gentry anymore.
How are you doing Martin, still on the tools ?
Andy
Re: unbelievable customers
I know I’ve been away quite a while, but I stopped being surprised by the things punters do a long time ago.
Re: whirlpool top loader 3RGSC9455JQ1
Hiya Suede: Give the guys on http://www.appliancejunk.com a try, they’re normally pretty helpful & know these machines better than we do.
AndyRe: Hoover HNMF 2605A L Fridge / Freezer.
Hi Bob: Thanks again for the reply, if you turn the control off then the fridge stops so a sensor fault as you said. The modules are apparently still available from HSCL, will go see the old lady & see what she wants to do.
AndyRe: Hoover HNMF 2605A L Fridge / Freezer.
Hi Bob: Thanks for the reply, the Fridge is starting to Freeze up at the back.
Been told these sensors are a bit of a Pig to replace :eeek:Andy
Re: Hoover HNMF 2605A L Fridge / Freezer.
Anybody by any chance got any service info for it ? going to look at it on Friday.
AndyRe: Hotpoint WDL540P UK
Hi Jim: Cheers mate, I’ve never had to replace the weight on 1 until now so thought it better to ask.
Andy
Re: Indesit wixxe127 keeps tripping rcd
As Woods said: It could be a faulty motor but given that you took all the hoses off to clean them, the 1st thing I’d check would be that you don’t have a leak onto the motor or heater.
Re: Diplomat ADP3620 – Timer separated from buttons
If the buttons aren’t springing back as they should then it’s quite possible that the button assembly has snapped, usually the only long lasting repair is by replacement. You could try taking it apart & if it has snapped glueing the parts together with Araldite but this may not last.
Re: Zanussi Washer dryer tripping RCCB once switched on.
Possibly an Earth Fault on the main motor or Wash Heater. You would need an Insulation tester to narrow down the fault.
Re: Heater stays on constantly
How good are you with a Multimeter & Soldering iron ? Try tracing the wiring from the thermistor back to the board & where it connects to the PCB check to make sure it’s got a good connection, do the same at the thermistor end as well.
