[suedehead1]

Re: wm63p door seal

its a different seal turn the old one upside down.

[suedehead1]

Re: wm63p door seal

if its the one with the groove in it change the clamp band

[suedehead1]

Re: John Lewis JLWM1203 washing machine doesn’t start

any fault code in the 50s is motor related the first thing i would always check would be the motor brushes average lifespan 5 years for brushes. 5 minutes would check them.

[suedehead1]

Re: John Lewis JLWM1203 washing machine doesn’t start

i would be looking at the motor brushes first.

[suedehead1]

Re: hoover HED6612/1-80 dishwasher.

Ok thanks I will give it a try.

[suedehead1]

Re: Neff s54t09x1gb/21 not heating

i would agree with faulty diverter valve.

[suedehead1]

Re: INDESIT IWME126UK Washing Machine

could be a fault with the display board emw can check it

[suedehead1]

Re: Wd12x indesit door lock problems

old lock must be faulty probably damaged the pcb.

[suedehead1]

Re: John lewis WM1404 won’t start

if you have meggered the motor and its ok then its the pcb

[suedehead1]

Re: hoover HED6612/1-80 dishwasher.

Hi anyone got any service info on this one?

[suedehead1]

Re: Hotpoint WT741 low water level on wash.

I had a problem with an indesit IWE91281 with the same fault, I changed the stupid wee blue pressure switch and it made no difference, I ignored it and a week later the heater melted a hole in the tub and it was scrap.

[suedehead1]

Re: hoover hdb854d/1-80 c0ntrol panel.

connect still saythat part no. is obsolete

[suedehead1]

Re: hoover hdb854d/1-80 c0ntrol panel.

thanks very much.

[suedehead1]

Re: indesit iwc6165

i always look to see if the lock terminals are numbered normally 3, 4, 5 to make sure the plugs on right i should only go in one way, if the old lock was burnt out it may have damaged the pcb.

[suedehead1]

Re: AEG L16830 Washer dryer

thanks very much

[Author]

Posts