Forum Replies Created
-
Posts
-
Re: Washing Machine Won’t Fit! Help Please!
I’ve no idea of the thickness of the current lid though.
It’s probably somewhere between 20 and 25mm at a guess.
Re: Washing Machine Won’t Fit! Help Please!
If there is one available for that model, it is probably no more than 1mm thick.
Obviously you would have to fork out for it though 😉 . Shouldn’t be too expensive though.
Re: Washing Machine Won’t Fit! Help Please!
If you contact BSH Appliance Care spares dept on 08705 543210 there may be a “tin lid” available instead of the normal lid.
Definately don’t remove either the feet or the lid :nono:
HTH
Re: Neff dishwasher not draining
Is is straightforward?
In a word no. If I was you I’d go down the engineer route.
Re: Washer – Whirlpool or Bosch
Bosch is around £100 more, so is it worth splashing the extra cash
Definately, in my opinion. You will get a two year guarantee also with the Bosch 😉 .
Re: Appliance repairs
mysterious flooded base problems.
Blame the 500 in 1 tabs for that one :rolls: .
Re: Bosch slimline D/W
Would a flooded base stop the machine from stepping from Off position to very first drain impulse?
If I remember correctly, yes. On the older d/w’s instead of running the pump all the time a flooded base cuts the feed to the timer motor.
So unfortunately it’ll have to come out 🙁
Re: Bosch WTL6300GB/01
To remove fascia, you have to prise it away with a screw driver from the underside.
As Martin said, door lock may be faulty.
Also had many customers call me out for similar, only to find child lock has been set :rolls: . Check the instruction manual for how to turn it off :rtm:
Re: NEFF S5555X not cleaning upper tray (arms OK)
is there a separate diverter valve
Indeed there is. However it’s not a DIY job to replace I’m affraid. Involves a complete strip down of the m/c.
I would double check the spray arm though. Also make sure it is on the highest setting and nothing is obstructing it.
Re: Bosch spin fault
I suspect the Module board is at fault,
Suspect you may be right Martin.
I don’t think fault codes are displayed numerically on that m/c, they tend to be displayed via flashing lights.
Will have a look for you later.
Re: Neff integrated washer
There were a few different 6544’s if you pull it out there should be a rating plate on the back.
Make sure you note ALL the numbers down.
We don’t even have any info on our laptops for them :rolls: . I had a problem trying to get a door seal for one last week as the preppers have to get the old microfiche out.
