Forum Replies Created
-
Posts
-
Sorry for the late reply on this one.
The pnc is 91153641800. The side chamber had a leak and it was also blocked. I replaced the chamber and also the pressure switch as I couldn’t get it to clear the fault. I checked for any further blockages but couldn’t find any. I ran it through a couple of rinses and also a quick 30 min cycle and all appeared fine.
I got a call this morning to say that it is showing I44 again.
Any pointers?Merv
If I remember correctly, you need to lift the hob from the rear and push the hob forwards to release it.
I had one a few weeks ago. Ordered from Qualtex and the packaging was suspect, also there was no clip in the box.
There is something quite wrong if they are supplying pattern parts when you have ordered and paid for a genuine part.
I have been so busy that I never got round to querying it.I couldn’t either.
I went through all the service info and have looked online but can’t find any mention of it anywhere.Hi Dave,
yes, I did on both ovens. Both ovens had been on and the resistance on both probes were in range with the chart in the tech info.I did one of these a couple of weeks ago.
I removed the right hand panel off as you look at the front of the the machine. Unhooked the drive belt and then the pump is located behind the motor pulley. I can’t remember if it was a t20 or t15 screw that needed removing and then the pump unclips.Merv
Thanks Ken, the other numbers that are on the machine are 9550-048822 which is shown as the serial number.
Merv
Hi,
I have ordered them from connect and Qualtex and both have the same issue.
The ones from connect arrive in a bag with the Electrolux label on them.Merv
Hi Dave,
I did order a set from eBay, but when they arrived the part number on the bag was 00626210 and they are slightly bigger and won’t fit.
